How do you reset the check engine light on a 2014 Subaru Impreza?
How to Reset a Subaru Check Engine Light
- Open the hood of your Subaru and loosen the nut that holds the cable clamp to the negative battery terminal.
- Slide the cable off the negative battery terminal.
- Wait 5 minutes, then reconnect the cable and tighten the retaining nut.
What causes a flashing check engine light on a Subaru Impreza?
While a majority of the time, the flashing check engine light is going to be caused by a misfire related to your Impreza’s ignition system or fuel system (as stated above), there are other issues that can cause it. Your timing chain could have jumped .
How to get DTC code on Subaru check engine?
Subaru Check Engine Light Codes 1 Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2 Turn the ignition on. 3 Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).
What happens if you ignore the Check Engine light?
While you may not need immediate service, never ignore the light. Doing so can seriously damage your engines components and leave you stranded on the side of the road. The Subaru Impreza was the third most stolen vehicle in Colorado in 2017.
What happens when the Mil comes on on a Subaru?
When the MIL comes on, the car’s On Board Diagnostic (OBD) system will generate an error code that a service department can use to determine what the problem is. There are OBD readers that you can purchase to allow you to scan for the codes, which you can then plug into Google for further research.
What does a Subaru check engine light mean?
If the check engine light in your Subaru is flashing, on the other hand, it means that something serious may be wrong with your engine. Often, the light flashes when there is a misfire , which is caused by unburned fuel being dumped into the vehicle’s exhaust system.
How do you reset the Check Engine light on a Subaru Outback?
Step 1 Open the hood of your Subaru and loosen the nut that holds the cable clamp to the negative battery terminal. Slide the cable off the negative battery terminal. Wait 5 minutes, then reconnect the cable and tighten the retaining nut. Start the engine and wait for the Subaru’s computer to reset the check engine light.
Why is your check engine light flashing?
A flashing check-engine light generally indicates that there is a failure in the emission control system. The emission control system contains an array of sensors that work to reduce the amount of pollution released into the air. An oxygen sensor reads the air and fuel mixture and lights up when it is out of range.