How do you reset the check engine light on a 2004 Ford F150?

How do you reset the check engine light on a 2004 Ford F150?

Drive the car for at least 15-20 minutes above 25 mph. If You’ve been starting and stopping excessively, the catalytic converter may be stressed and driving at highway speeds should clear the CEL. Disconnect the positive battery cable for 15-20 minutes.

Why is my check engine light on F150?

If the check engine light in your 2021 Ford F-150 starts blinking, that means that the problem needs immediate attention and your Ford should be transported in quickly. This blinking light typically indicates a serious engine misfire allowing unburned fuel to be dumped into the exhaust system.

How do you check the codes on a Ford F150?

Turn the key on to accessory. Keep holding the button until the words TEST appear. Once the words TEST appear let go of the odometer button and press it again to cycle through the onboard test. Push the button to dtc which will give an error codes.

Why does my 2005 F150 shake when I accelerate?

A misfiring engine is one of the most common reasons your F150 will shake when accelerating. A vehicle’s ignition system consists of spark plugs, coil packs, and maybe plug wires. If it is an older model, it’ll have a distributor and coil instead of coil packs.

How do you clear a Ford F150 code?

OBD II

  1. Locate the diagnostic link connector (DLC) beneath the driver’s side dashboard.
  2. Plug the pocket scanner into the DLC and turn the ignition key two clicks to the key on/engine off position.
  3. Follow the procedures for the pocket scanner to erase the codes.

How can I check my service engine light without a scanner?

Depress the odometer “Trip” and “Reset” buttons while simultaneously turning the ignition key “On” and “Off.” End with the key in the “On” position. Release the odometer buttons and read the trouble codes from the digital odometer.

Why does my 2004 F150 shake?

Why an F150 shakes when idling Misfire: An engine misfire may lead to more engine vibration and shaking, especially during idling. Addressing the source of a misfire will remedy this issue. Faulty or dirty plugs: If the spark plugs are dirty or worn, it may cause misfires which leads to shaking in the engine.

What kind of engine is in a 2004 Ford F150?

The Triton family of engines included the 4.6L and 5.4L V8 engines, as well as the 6.8L V10 engine. This featured 2004 Ford F150 5.4 Triton was released in 2004, is the 5.4L size and features 3 valves per cylinder for a total of 24 valves.

What kind of engine does a Ford F150 have?

The all-new, aluminum cylinder head – with two intake valves and one exhaust valve per cylinder for 24 valves in total – and a new cast-iron block balance this impressive power with better fuel efficiency and quieter operation.

What causes a Ford F-150 engine to turn off?

5.4 Triton Engine Failure of the Fuel Pump Driver Module This problem is typical for the Ford F-150 with a 5.4 Triton engine. Failure of the fuel pump driver module usually cuts off the petrol feed to the engine which, of course, causes the engine to turn off, thus cutting power to all essential systems.

Is there a problem with the Ford F-150 Triton engine?

Ford technicians will diagnose the problem, identify misfiring cylinder (s), and replace the spark plug and coil where needed. This problem is typical for the Ford F-150 with a 5.4 Triton engine.