How do you reset a Polo Vivo throttle body?
With the car off, push the accelerator all the way to the floor. Then turn your key to the ‘on’ position (do NOT start the car) and wait at least 10 seconds. Release the accelerator, then take the key out.
How do you adjust the idle on a diesel engine?
Idle Speed Adjustment Gently push the linkage rearward to take the pressure off and turn the idle screw counter clockwise (up) to increase idle speed, turn the idle screw clockwise (down) to decrease idle speed. Check the RPM and adjust idle speed screw until the correct idle speed is achieved.
What kind of engine code is a VW Polo?
my car is a VW Polo Classic 1.4 16V. the engine code is APE, I already cleaned the throttle body, the EGR valve, I changed the crankshaft sensor, I also changed the coolant sensor but it was not that sensor. The MAF sensor has also been cleaned and continued the same, the next step is to buy a new one and test.
How do you know what idle settings you have?
Recheck mixture screw to lean best idle again. If all is still best and smoothest idle then confirm and note the final settings. To confirm settings with the engine running. Start by screwing in the mixture screw and count the number of turns it takes to bottom out and note if the engine dies.
What’s the best way to adjust the idle speed?
Use your ear, not a scope or tuning instruments at this point. You want to tune the engine by sound. Adjust to best, fastest and smoothest running point. 4c. Now that the mixture screw is at its best running location, you can adjust the idle speed the screw.
Which is the correct size of idle jet screw?
Go down on the primary idle jet Mixture Screw more than 2 turns out Go up on the primary idle jet Mixture Screw between 1 and 2 turns out Primary jet is correct size It is important to follow all linkage and lever installation instructions.