How do you reset a Pats car alarm?
To reset the vehicle’s alarm, put the PATS programmed key in the ignition and turn the key to the “on” position. Press the override button. When the alarm resets, it chirps two times and the LED light begins blinking.
Can a PATS system cause an alarm to go off?
PATS will not cause the alarm to go off. Remote Entry/Keyless Entry problems: PATS is completely separate from the Remote Entry/Keyless Entry systems. There is a no-crank problem on vehicles without PATS starter disable. Check Table 1, for presence of Starter Interrupt.
Do you need to reprogram ignition keys for Pats?
Erasing and reprogramming ignition keys does not cure any known intermittent PATS no-start issues. Do not reprogram keys if a fault cannot be identified. Always verify that there are no aftermarket devices causing interference, such as alarms, remote starters or other devices utilizing transponders.
How to disable anti theft in vehicles ( Pats )?
Press the unlock button on your vehicle’s key fob to deactivate the alarm. If you’ve misplaced your remote for the car, use the PATS programmed key to unlock the driver’s side door. Then, put the key in the ignition and turn the key to the “on” position. The vehicle’s battery should be on, but the engine shouldn’t be running.
How to relearn Pats ignition key code program?
Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”
Can a Ford Pats disable the engine on the road?
Engine stalls on road: Once the engine runs for one second, PATS CANNOT disable the engine. Running stalls are not PATS related Remote Entry/Keyless Entry problems: PATS is completely separate from the Remote Entry/Keyless Entry There is a no-crank problem on vehicles without PATS Starter disable.
Press the unlock button on your vehicle’s key fob to deactivate the alarm. If you’ve misplaced your remote for the car, use the PATS programmed key to unlock the driver’s side door. Then, put the key in the ignition and turn the key to the “on” position. The vehicle’s battery should be on, but the engine shouldn’t be running.
How to run Ford Pats relearn procedure module?
Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.” Disconnect Tool and leave key in RUN for 20 seconds. 1 key required. Cycle key 1 to RUN, then OFF. Cycle new key to RUN. 2 keys required. Cycle key 1 to RUN, then OFF. Cycle key 2 to RUN, then OFF. Cycle new key to RUN. Cycle a key in ignition to RUN.