How do you replace the timing belt on a Hyundai Elantra?
Remove the Timing Belt and Pulleys Unbolt and remove the Timing Belt Tension Pulley (left side of the engine). Using a box wrench, slightly move clockwise (1 degree) the Camshaft Pulley and remove the belt. This slight advance in the camshaft will allow some belt slack to ease new belt installation.
How does the timing belt tensioner work on a Hyundai?
Tension in the drive is increased by rotating the eccentric counterclockwise as indicated by the arrow stamped on the tensioner. After performing a thorough analysis of the timing system on these vehicles, Gates engineers have determined a need to highlight proper installation and setup procedures of the timing belt tensioner.
What’s the torque on a Hyundai Elantra tensioner?
Torque the bolt to 32-40 ft. lbs. on Tucson models, and 17-22 ft. lbs. on Elantra and Tiburon models. The torque procedure is as follows: Turn the mounting bolt clockwise while applying counterclockwise pressure on the tensioner via the eccentric with an Allen wrench.
How do you check the tension on a timing belt?
Once the mounting bolt is torqued, verify correct tension in the drive by turning the engine two complete revolutions. If the pointer is still centered in the window, proceed with reassembly. Otherwise, loosen the mounting bolt and repeat the above procedures.
When do you change the timing belt on a Hyundai?
On average, your Hyundai timing belt should be replaced between every 60,000 and 100,000 miles. Since it carries a huge load of tension, it’s susceptible to wear leading to cracking, stretching or even snapping of your Hyundai timing belt.
How much does it cost to replace a timing belt on?
“Now, more people know about it and what can happen when it breaks.” Replacing a timing belt for preventive reasons typically costs $500 to $900 . However, replacing a broken timing belt may cost up to $2,000 or more if it caused damage to the valves, pistons or water pump.
Is a Hyundai Elantra an interference engine?
From 2011 to 2020 all Hyundai Elantra models have a timing chain and an interference engine . From 1992 to 2010 all Hyundai Elantra models have a timing belt and an interference engine. Scroll down for detailed information on your particular model year. Check Out Belt Or Chain For Other Makes And Models
What causes a Hyundai Elantra engine to break?
This is an “interference” engine application which means that if the timing belt were to break when the engine is operating, the valves could interfere with the pistons causing the engine to be damaged.
Can a timing belt be replaced with an engine?
1) That interference engine thing again; and 2) Every camshaft and crankshaft on planet Earth is indexed to No. 1 TDC. If you try to remove and replace the timing belt with the engine in any other position, chances are good you’ll throw things out of time.
How do you remove tension from timing belt?
The easiest method on removing bolt tension is with a ¼” 10mm socket attached to an extension and a ¼” ratchet wrench. While hold the pulley with the right hand, apply torque to the ratchet wrench to remove the bolts.
How much does it cost to replace a timing belt?
The average cost for a timing belt replacement is between $498 and $669 . Labor costs are estimated between $319 and $403 while parts are priced between $179 and $266 .
What are the benefits of replacing a timing belt?
- Increase in Horse Power. Taking your vehicle to a timing belt replacement shop and changing the timing belt as scheduled will benefit you in many ways.
- Better Fuel Economy. Changing the timing belt when needed will dramatically increase your gas mileage.
- Lower Auto Repair Cost.
Should the timing belt be replaced?
If your car has a timing belt, it’s important that you inspect it regularly to ensure that it’s in proper working order. This small part is critical to your engine running properly, and if it breaks the results can be catastrophic. Your timing belt should be replaced every 50,000–70,000 miles, depending on your car’s make and model.
Is it important to replace my timing belt?
The importance & benefits of replacing your timing belt. Your timing belt helps run many fundamental parts of your car, including the vehicle’s engine, alternator, air conditioner and power steering pump. In older vehicles, the standard timeframe to replace a timing belt is around 60,000 miles.
How do you replace the water pump on a Hyundai Elantra?
While hold the pulley with the right hand, apply torque to the ratchet wrench to remove the bolts. If replacement of the Water Pump is desired, the alternator mounting bracket will require removal. The pump can then be unbolted, jarred loose and removed. 4. Remove the Crankshaft Pulley
Can a timing belt be replaced with a water pump?
Gates makes an acceptable Timing Belt Component Kit (belt, two pulleys, and water pump). Since the water pump is not driven by the timing belt, you do not save much time or cost by replacing the pump along with the timing belt.
Remove the Timing Belt and Pulleys Unbolt and remove the Timing Belt Tension Pulley (left side of the engine). Using a box wrench, slightly move clockwise (1 degree) the Camshaft Pulley and remove the belt. This slight advance in the camshaft will allow some belt slack to ease new belt installation.
How much does a timing belt replacement cost?
Know what price you should pay to get your vehicle fixed. The average cost for a Hyundai Elantra timing belt replacement is between $431 and $578. Labor costs are estimated between $260 and $329 while parts are priced between $171 and $249. Estimate does not include taxes and fees.
The easiest method on removing bolt tension is with a ¼” 10mm socket attached to an extension and a ¼” ratchet wrench. While hold the pulley with the right hand, apply torque to the ratchet wrench to remove the bolts.
What happens if your timing belt goes bad?
If the timing belt is starting to go bad, the engine will run poorly and the check engine light will likely come on. If the belt breaks, the engine will stall immediately, and internal engine damage can occur.
Can a broken timing belt cause a blown head gasket?
However, replacement of the water pump/alternator belt along with the timing belt is highly recommended. A broken belt will quickly lead to the engine overheating and may result in expensive repair (i.e. blown head gasket).
When should you change the timing belt on a Hyundai Accent?
Hyundai states the timing belt on an Accent should be changed every 60,000 miles. The timing belt stretches over time and the automatic belt tensioner self-adjusts to keep the belt tight, however, when it reaches its limit of travel it stops as the belt continues to stretch.
Do Hyundais have timing chains?
But, indeed, Hyundai did, when it announced that all Genesis engines use a chain. They’ve got a point—to some extent. Timing chains last the lifetime of a vehicle, while timing belts have prescribed replacement intervals.