How do you replace brake pads on a Mitsubishi Lancer?
Place the wheel away from the car. Turn the twin rear mount bolts on the caliper in a counterclockwise direction, then slide the caliper off the rotor. Replace the two pads on the caliper by pulling them free of the caliper pistons, then positioning two new pads in their place. The new pads will rest in place but will not be secured to the pistons.
How do you change the brake shoes on a car?
You can then use a ratchet to remove the axle bearing nut and pull off the brake drum. Then, pull off the brake shoe springs, clips, and cable so you can pull off the old brake shoes. Slide the new brake shoes into place and reconnect all of the springs, clips, and cables so you can replace the drum and axle.
What kind of oil do you use to replace brake shoes?
Apply a light film of high-temp grease to the flat spots where the shoes contact the backing plate. Note: If you use a penetrating oil like WD-40 or PB Blaster, remember these are not lubricating oils. You’ll need a separate grease for lubrication of the brake backing plate.
How do you change the brake Springs on a car?
Reconnect the brake springs you disconnected in order to remove the old brakes. Use a pair of pliers to ensure you don’t pinch or injure yourself in the process. If the springs become too bent or damaged in the process, they will have to be replaced. Be careful not to overstretch the ends of the spring.
You can then use a ratchet to remove the axle bearing nut and pull off the brake drum. Then, pull off the brake shoe springs, clips, and cable so you can pull off the old brake shoes. Slide the new brake shoes into place and reconnect all of the springs, clips, and cables so you can replace the drum and axle.
How do you remove a parking brake drum?
The parking brake drum, which is part of the brake rotor, must first be removed. There are some springs that keep tension on the shoes that need to be removed using a needle-nose pliers, or a special drum brake tool. Once the parking brake shoes are free, the cable spring is compressed to remove the cable from the shoe.
Reconnect the brake springs you disconnected in order to remove the old brakes. Use a pair of pliers to ensure you don’t pinch or injure yourself in the process. If the springs become too bent or damaged in the process, they will have to be replaced. Be careful not to overstretch the ends of the spring.
How do you remove the brake pads from a car?
Use pliers to remove the primary brake shoe springs. The primary brake shoe springs are the large springs located beneath the drum once you remove it. Some vehicles will have one spring for each brake pad, while others may have two. All of the springs will need to be disconnected to relieve the tension and allow you to remove the pads.