How do you replace a top load washer gear case?
Release the locking tabs on the wire harness connection and pull the wire harness out of the connector on the shifter. Disconnect the motor wire harness. Pull the wire harness connector off the capacitor. Release the wire harness retaining clips from the gear case housing.
Can a car be converted from right hand drive to left hand drive?
The entire process to convert right-hand drive to left-hand drive is not a simple process and thus should be done under the supervision of the expert. Any minor mistake while the rhd to lhd conversion can result in some issues with not only the car but also for the people driving in the car.
What kind of gearcase can I get from Sei?
The gearcases offered by SEI are fully compatible and interchangeable with Mercury, Yamaha and Johnson Evinrude gearcases. SEI is currently producing gearcases for V6 outboards.
How do you reposition a steering wheel in a car?
1. Repositioning Of The Steering Wheel Dismantle the entire steering wheel along with the portion beneath the steering wheel. The main need is to reposition the steering wheel to the other side of the car.
How do you remove the gear case bolts?
When you get these 6 bolts removed, the gear case unit should drop down about 1/2”. If it does not you may have to tap it with a plastic mallet. Shift the gearshift into reverse to pull the lower shifting rod up allowing access to the connector retainer bolts now visible by the blue arrow in the photo below.
How does a Mercury Marine gear case work?
Mercury Marine gear cases have a mixed ratio of lower units. Some of them require you to pull the bearing carrier in order to change out the prop shaft seals. Then the other half you can change them without pulling the carrier. For the gear cases that you have to pull the carrier on.
Do you need to replace reverse drive gears?
You might get away with just replacing the slider, or possibly may need both the drive and forward and reverse drive gears. You usually can clean up the recesses in the gears by using a carbide cutter in a hand held Dremel tool. There are two versions a 2 lug and a later 3 lug versions.
What kind of tool do you use to clean gears?
You usually can clean up the recesses in the gears by using a carbide cutter in a hand held Dremel tool. There are two versions a 2 lug and a later 3 lug versions.