How do you replace a CPS sensor on an engine?

Back of engine, near the firewall. Unplug the electrical connector from the CPS sensor. Squeeze the connector and pull it away from the CPS sensor. Remove bolt. Remove the crankshaft position sensor. You will have either an E8 or E10 bolt that holds the CPS sensor in place. Install new sensor.

What kind of car is the 2005 Mercedes-Benz C 180?

2005 Mercedes-Benz C 180 Kompressor (man. 6) (Classic, Elegance, Avantgarde) (model for Europe ) car specifications & performance data review Specs datasheet with technical data and performance data plus an analysis of the direct market competition of Mercedes-Benz C 180 Kompressor (man.

What was the Mercedes C 180 Kompressor in 2005?

Examples of the direct competition of Mercedes-Benz C 180 Kompressor in 2005: The same class cars with similar performance (1/4 mile times) and kind of fuel, with manual transmission: The same class cars with similar performance (1/4 mile times) and kind of fuel, with automatic or automatized transmission: Visit us on Facebook !

Is the Mercedes-Benz crankshaft position sensor problem?

So you can start digging using that info and see what you think. Lots of cars including the Mercedes-Benz are known for having crankshaft position sensor problems. However, when failure of this component becomes suspected an automotive scan tool that reads the data stream is the easiest way to uncover the issue.

Where is the crankshaft position sensor on a Mercedes Benz?

Locate the crankshaft position sensor (CPS) on driver’s side, towards the rear of engine. Back of engine, near the firewall. This opens in a new window. Unplug the electrical connector from the CPS sensor. Squeeze the connector and pull it away from the CPS sensor. This opens in a new window. Remove bolt. Remove the crankshaft position sensor.

Where is the Check Engine light on a Mercedes Benz?

The check engine light is usually illuminated on your instrument cluster. You can easily use a $20 scanner to read the fault code which will tell you why the check engine light is on. When the CPS is malfunctioning, the engine control module will trigger a fault code if it does not receive any signal from the CPS.

When did the Mercedes Benz 300 CE come out?

Modeled after the flagship SEC, the dashing four-place 300 CE made its debut at the 1987 Geneva Motor Show. Its wheelbase and overall length were 3.3 inches shorter than those of the sedan, and it only shared that car’s front section and taillamps, utilizing a more steeply raked windshield and rear window for aerodynamics and style.

How much horsepower does a Mercedes 300CE have?

Better breathing and a 10:1 compression ratio brought quite a power bump: 217 hp at 5,500 RPM and 195-lb.ft. of torque at 4,600 RPM. The rare factory Sportline package, introduced in 1992, brought a lowered, firmer suspension, altered steering ratio, wider (15 x 7-inch) wheels and tires and specific badging.

How did I change the crankshaft position sensor?

1st though, I pulled out the camshaft sensor and thought that was it. It was not. Then I found the crankshaft sensor and replaced it without any problems and now the engine won’t fire. Relearn.

What happens if the crank sensor is not hooked up?

The crank sensor directly affects your ignition. If its not hooked up right, you will get intermittent or zero spark. Click to expand… I suppose anything is possible but I tried to be gentle.

Navigation