How do you remove the timing belt on a DOHC engine?
Before removing the belt, you need to tie the camshafts ends together using the specific tool. 1- Block the right hub by inserting a screwdriver in the brake disc from beneath. 2- Put the 4th or 5th or 6th gear. 3- Use the left wheel to rotate the engine and watch the camshafts ends.
Where is the timing belt on a car?
On many cars the timing belt is easily seen by removing the plastic timing cover on the front of the engine, usually held on by a couple of Phillips head screws or clips. On some vehicles, it’s more involved to access it, but it’s always on the outside of the engine and accessible in some way.
How often do timing belts need to be replaced?
Timing chains do not need to be replaced as often as timing belts, but they do tend to be more expensive to replace if they every need servicing. Your vehicle’s repair manual will be able to tell you what type of engine you have, as in timing belt or timing chain.
When to replace timing belt on Toyota Tundra?
Tundra If you own a 2000 to 2004 V6 Tundra get ready for a replacement by 60k miles. For a 4.7 V8 engine made between 2000 and 2009, prepare to replace the belt when the mileage reaches 90k miles.
When to replace head gasket and timing belt?
2003 Honda Civic Head Gasket and Timing Belt Replacement: An Instructable for the moderately experienced, mechanically inclined Honda owner that doesn’t want to donate a kidney just to keep his or her car on the road. These instructions are not a guide for HOW to replace a head gasket and timing belt…the…
How do you change timing belt on Honda Civic?
Once aligned, slip the timing belt over the teeth and pull the pin on the tensioner. The belt will tighten nicely without moving the the gears past their markers. Use a 19mm socket and the crankcase bolt to move the pistons a couple of counterclockwise revolutions. re-check alignment; it should be the same.
How to repair the timing chain on a Hyundai Sonata?
1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). 3. Remove the air duct (B). 4. Remove the air cleaner assembly. Disconnect the breather hose (A), the intensifier hose (B) and the brake booster vacuum hose (C). Disconnect the air intake hose (D) and then remove the air cleaner assembly (E). 5. Remove the RH front wheel.
Do you have to replace head gasket every time you replace cylinder head?
Don’t ever re-install a cylinder head that has not been professionally re-surfaced and examined for cracks. Check the service manual for the head bolt specifications to see if the bolts need to be replaced whenever the head gasket is replaced. Some bolts are what is called torque to yield type and would need to be replaced