How do you remove the rear wheels on a Porsche 928?
Put the 928 up on jack stands or a lift. All of your work will be at the rear of the car – removing the rear wheels will give you more room to work comfortably, and lighting will be a bit better. Figure 3. Use a wheel wrench to remove the rear wheels.
Where is the tail light housing on a Porsche 928?
You’ll find it in the trunk. Remove the carpeting, and pull it out by twisting the two tabs. You need it out of the way to get to the tail light housing. Figure 1. 928 tool tray. Use your spark plug spanner to unbolt the hex nut that’s holding the tail light housing in place, and remove it from the rear bumper. Figure 2.
Can you take the fuel tank out of a Porsche 928?
It almost goes without saying that you should only begin work on a fuel tank that is empty. Run your 928 engine normally to remove as much fuel from the tank as possible.
How to remove the center nut on a Porsche 914?
You will also need a large socket (29-30mm for the 356 & 914) to remove the center nut. The procedure is simple: clamp down and lock the club around the steering wheel. then position the breaker bar within gripping distance of the club.
Where are the ground wires on a Porsche 928?
One is at the top of the “O” in the word Porsche cast into the cam cover — and it may be covered-up by the emissions air injection valve/hose. The second attachment point on the cam cover is more visible and is closer to front of car. Point 10 For later Euro cars, look for ground wires attached to the back of cam gear metal rear covers.
Where is the injector harness on a Porsche 928?
They ground the engine electronics & the injector harness. One is at the top of the “O” in the word Porsche cast into the cam cover — and it may be covered-up by the emissions air injection valve/hose. The second attachment point on the cam cover is more visible and is closer to front of car.
How to remove the steering wheel on a Porsche 914?
On the 356s & 914s, this is accomplished by holding the wheel and twisting the center horn button in a counter clock-wise direction. This is displayed in Figure 1, as shown on a 914. When removing the horn button assembly, be sure to be careful of the horn signal wire which is attached to the center horn button assembly.
What’s the center nut on a Porsche 912?
This nut is 27mm on the 911 and 912. An alternative safe method involves using a 2-ft breaker bar or socket wrench, and the anti-theft device called The Club. You will also need a large socket (29-30mm for the 356 & 914) to remove the center nut.