How do you remove the lock cylinder on a Golf GTI?
We removed them for photographic purposes. To remove the lock cylinder you will need a firm paper clip or 3/36-inch drill bit to inset into the hole in the ignition cylinder (red arrow). Gently separate the connection for the inductive coil (red arrow). Insert the key and turn it 90 degrees to the “on” position (red arrow).
How do you unlock a Volkswagen Golf GTI MKV?
Break the seal on the end cap on the electrical connection and gently pry it from the end of the barrel (red arrow). You will need to insert a pick or very small tool between the electrical piece (red arrow) and the barrel (yellow arrow).
How do you turn on the ignition on a Golf GTI?
Insert the key and turn it 90 degrees to the “on” position (red arrow). Insert your paper clip approximately an inch and half into the hole in the cylinder (red arrow).
How to remove ignition lock housing ( unit ) VW Golf?
Loose the bolt from the signal and wiper arms using a 4 mm inbus and then take them out from the steering column 8. Remove the 8 mm nut 9. Remove the 13 mm bolt using a 13 mm socket and a 10 mm socket 10. Remove those two bolts from the ignition lock housing
What causes a Volkswagen Golf key to get stuck in the ignition?
If your Volkswagen Golf’s battery doesn’t have enough voltage to properly engage the safety mechanisms that leave your key stuck in the ignition can cause the issue. How to Get Key Unstuck: Volkswagen Golf. Here are ways that you can get your Golf’s key free. This is our recommended order to do them in. Make Sure You Have Voltage
Do you need to replace the ignition switch on a Golf GTI?
If you let the cylinder get to the point where you can no longer turn the key in the ignition, you will end up having to replace the entire ignition switch assembly. You will need to remove the stalk switches to replace the whole assembly.
When to replace ignition switch and lock cylinder?
The inductive coil, ignition switch, lock cylinder and assembly are all prone to failure. If you suspect that the lock cylinder or tumbler is starting to go bad or that your key is starting to act up in the ignition, you should replace the cylinder ASAP.