How do you remove the handle from a window winder?
This is achieved by removing the handle (F) by unscrewing the retaining screw (H). Next, release in any order, the door chain, the handle which is pulled to close the door, the lock mechanism and the pins which hold the oilcloth covered plywood to the door frame.
How does window winder work on Austin Seven?
With a dull click my window disappeared down into the door recess of my Seven. On all previous occasions there had always been about an inch showing above the aperture in the door-frame. When I then attempted to wind-up the window to close it the whole lot speedily descended whilst at the same time the window handle pirouetted gracefully clockwise.
How to remove a quarter window from a door?
Remove the door quarter window. 25 Detach the window channel from the regulator ball and socket joints then raise and remove the window from the interior side of the door. 26 Refitting of the door glass is the reversal of the removal procedure.
Why is my window winder coming away from the door?
With a downwards and outwards pull this will come away from the door and leave exposed the winding mechanism. In unrestored cars this is the time to notice deterioration around the bottom edge of the door.
This is achieved by removing the handle (F) by unscrewing the retaining screw (H). Next, release in any order, the door chain, the handle which is pulled to close the door, the lock mechanism and the pins which hold the oilcloth covered plywood to the door frame.
With a dull click my window disappeared down into the door recess of my Seven. On all previous occasions there had always been about an inch showing above the aperture in the door-frame. When I then attempted to wind-up the window to close it the whole lot speedily descended whilst at the same time the window handle pirouetted gracefully clockwise.
What should I do if my window winder has broken?
It may be necessary to give the square arm on (E) a gentle tap to release the spool and spring. It is the spring (C) which is usually broken. At each end the spring should be bent inwards at right angles as shown in the diagram (J). It is one or both of these ends which will be found to have broken.
How does a winder work on a window?
Once released the winding gear can then be lowered making it possible to slide the two runners out of the channel under the window glass leaving the window itself still in place. Next comes the tricky bit. The drum (E) is attached to the main plate by five lugs which must very carefully be prised open.