How do you remove the fog lights on a Citroen c2?
To take the fog lights out, pull the flap down underneath the front bumper behind each foglight, you’ll find a 10mm nut, undo this and you can remove the foglights.
What are the factory switches on a C2 headlight?
The factory switches are used to turn on the little lamp in the dashboard alerting you that your headlights are on when the doors are closed. We are repurposing them, converting them to limit switches. These are normally closed switches, which means that when the switch is not pressed, a connection is made.
What happens when you turn off the headlight?
The motor is powered until the Y-stop hits the switch, which breaks the circuit. When the headlight switch is turned off, the relay opens, sending power to the 87a terminal. This sends power to the close circuit, closing the headlamp buckets until the stops hits the closed switch, killing the power.
What was the first year Corvette had rollover headlights?
The C2 Corvette (63-67) is the first year Corvette had rollover headlights. All you have to do is ask anyone what is the most difficult part of restoring a C2, and the answer is always the headlights. The problem is that the only real information out there is a single exploded diagram from the GM service manual showing one side of the headlights.
Where is the limit switch on a headlight?
Our car was missing the switch and because we were updating the car, we updated the controls too. Using the original headlamp warning lamp switches (located on the motor mechanism) as limit switches, the headlights now open and close when the headlight switch is operated. All you need is a standard relay and some wire.
How do you replace a headlight motor on a corvette?
An additional 10mm bolt should also be removed from the bracket. headlight assembly can now be placed on a towel on your work bench. about to begin! headlight motor from the headlight assembly. bracket. Spray some WD-40 on the heads to help loosen them. small retaining ring on the very end of the shaft.
How do you replace the bushing on a headlight?
Place the three new delrin bushings in the bottom half and replace the top half. for this. housing. It will be tight due to the way the teeth in the gear are cut. will put it in place. Replace the gear cover them. its original position. the headlight motor back into the headlight assembly.
How do you replace a bushing on a corvette?
Separate the two halves and the gear. Place the three new delrin bushings in the bottom half and replace the top half. for this. housing. It will be tight due to the way the teeth in the gear are cut. will put it in place. Replace the gear cover