How do you remove main drive gear bearing?
Note that the flat side of the clip faces the bearing. The rounded, concave side faces away from the bearing. Now, it is possible to remove the remaining half of the Harley main drive gear bearing. The fitment if the remaining bearing and race is not very tight. Both pieces can be easily tapped out with a plastic hammer or a brass drift.
How do you replace the main drive gear?
Remove the main drive gear inner seal (or, mainshaft seal) and replace. Then, slide a new o-ring over the gear and set it aside; ready for reinstallation. Pry off the main bearing seal and remove the bearings’ retaining clip.
Do you need to replace the main drive gear bearing on a Harley?
If you have dismantled your Harley six speed transmission to this point, it is probably because you need to replace your Harley main drive gear bearing (sixth gear). At this point, the main drive gear needs to be removed. To remove this gear, a specialty tool is needed.
What’s the best way to replace a wheel bearing?
Step 5: Install the new bearing. Place the new bearing into the back of the rotor and apply grease to the inside bearing cavity. Install a new bearing seal over the new larger bearing and slide the rotor back on to the spindle. Tip: A rubber mallet can be used to tap the bearing seal into place.
Note that the flat side of the clip faces the bearing. The rounded, concave side faces away from the bearing. Now, it is possible to remove the remaining half of the Harley main drive gear bearing. The fitment if the remaining bearing and race is not very tight. Both pieces can be easily tapped out with a plastic hammer or a brass drift.
Remove the main drive gear inner seal (or, mainshaft seal) and replace. Then, slide a new o-ring over the gear and set it aside; ready for reinstallation. Pry off the main bearing seal and remove the bearings’ retaining clip.
If you have dismantled your Harley six speed transmission to this point, it is probably because you need to replace your Harley main drive gear bearing (sixth gear). At this point, the main drive gear needs to be removed. To remove this gear, a specialty tool is needed.
Can a center support bearing be replaced on a driveshaft?
The center support bearing for the driveshaft is simple in design and function. It can be difficult to replace due to the driveshaft’s complex build.