How do you remove an airbag from a car?
The airbag should pop out of the steering wheel. Pull the airbag off of the wheel and unplug the airbag from the steering wheel. To store the airbag, make sure that the face of the airbag points up in the air. Otherwise the airbag could become a projectile if accidentally activated.
How long does it take to remove steering wheel airbag?
Removing the steering wheel airbag from the Vehicles is a job that you can do in about an hour. Pop the hood and disconnect the negative terminal on the battery using an open-end wrench. Allow the truck to sit for at least 20 minutes before you work on the airbag.
Where are the airbags located on a GM car?
This will unlock the wheel and allow you to move it in either direction and help you access the mounting bolts or release clips (On Gm vehicles) which are located on the backside of the steering wheel cover. Now grasp the steering wheel and turn it 90 ° locating the first mounting bolt or clip upward.
How to remove an airbag on a 1998 Chevy K-1500?
How to Remove an Airbag on a 1998 Chevy K-1500. Pop the hood and use an open-end wrench to disconnect the negative terminal on the battery. Allow the truck to sit for 30 minutes before moving on to Step 2. Place your key in the ignition and turn it to the “On” position. Turn the steering wheel to the left, 90 degrees from center.
How to remove the airbag control module in a car?
Steps To Removing Your Airbag Control Module First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats,… Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs.
How do you remove airbag from steering wheel?
For some applications the bolts will be retained in the wheel and will not come out which is normal. Once one side has been removed or released turn the steering wheel in the opposite direction 180°. Then locate and loosen or remove the opposing mounting bolt or retainer clip. Gently grasp the assembly while pulling it away from the steering wheel.
How long does it take to remove a side airbag?
As you can see by the image below the side airbag stands in the way of the window regulator. Begin with the vehicle on level ground with the transmission in park, set the emergency brake. Performing a removal and replacement is not too difficult and can be done using everyday tools. This job will take about an hour.
How to install front airbags in a car?
Turn the steering wheel to gain access to each of the driver air bag module bolts or attachment pin bores. Remove all hardware as necessary. Disconnect wiring, horn wire, grounding strap, airbag connectors and any wire for radio, cruise or added steering wheel controls (as available).