How do you remove a Mercedes lug nut?
Lift up the trunk floor and you will find a Mercedes-Benz spare tire, lug wrench, and a car jack. Using your lug wrench, loosen the lug nuts on the flat tire. Be sure not to remove the lug nut completely. Loosen them approximately one turn.
How to replace front wheel on Mercedes W202?
Place jack stand supports under the car. Loosen the lug nuts. Remove front wheel. Remove the lug nuts and remove the front wheel. Undo the wheel nuts and remove the wheel. Remove the brake caliper. There are two 17 mm bolts on the back that need to be removed. Use the breaker bar to loosen and then remove these two bolts.
How much does it cost to repair a Mercedes Benz wheel?
For a description of applicable cosmetic wheel repair limits, see your Mercedes-Benz dealer. Rental car reimbursement for up to Two (2) days, at $50 per day ($100 maximum benefit), in the event that a vehicle inspection is required or a covered repair requires shipment of damaged wheels
How to replace a front wheel bearing on a Mercedes Benz?
The dust cap can be used by using a flat head screwdriver. You may need to tap it with a hammer if there is rust or if the cap has not been removed for an extended period of time. If the cap does not come off, spray some penetrant fluid such as WD-40 and let it sit for about 10 minutes.
How do you reset the ECU on a Mercedes Benz?
Once both windwos are all the way down make both swithches click by pressing them all the way down. This lets the ECU learn that that is the end of the window track and it records it in memeory. Do the same closing the windows by holding both switches and making them click once the windows are all the way up.
What happens when you charge the AC in a Mercedes?
If the refrigerant level is very low, the AC compressor will not engage. Charge the AC system for a couple of minutes with the engine running, and you should notice the AC compressor engage / kick in once you add enough refrigerant into the system.
When to replace shocks on a Mercedes-Benz W210?
With most W210’s reaching 150,000 miles or more, it’s not uncommon to see wheel bearings starting to wear out. Follow this fool-proof guide to replace them in a jiffy! Replacement of your rear shocks and springs is one of the most common procedures for your W210 Mercedes-Benz.
Why is my Mercedes Benz W210 not working?
Old, worn out oxygen sensors can cause poor mileage, low power and a variety of fuel injection problems. Learn to replace them today with our article. The mass air flow sensor on the W210 is notorious for failing. Replacement is just a 15 minute job with this handy technical article. Over time, fuel injectors can get clogged and stop working.
What should the pressure be on a Mercedes Charger?
If the pressure is normal then the gauge should be in the green zone. You should not have a reading on the HIGH / RED zone except when the car is turned off, in which case it is normal. Always keep the can UPRIGHT. As you charge the system shake the can slightly every two or three seconds while you are charging.