How do you remove a jeep radio?
Drop the door down as far as possible. Reach behind the radio by sticking your hand behind the right side of the radio through the glove box. Use a 10-mm wrench to remove the nut holding the back of the radio. Pull out the radio, unplug the harnesses and antenna and remove it from the dash.
How do you remove a factory radio in a Jeep Wrangler?
How to Remove a Factory Radio in a Jeep Wrangler. Turn off the ignition, set the parking brake and remove the keys from the ignition. Pry up on the vent trim panel at the top of the dashboard with a panel tool to remove the panel. Remove two Phillips screws from the top edge of the trim panel that surrounds the receiver and climate controls.
Is there a reset button on a Jeep Wrangler?
There will not be a reset button unless it is an aftermarket stereo. Also, if it is an aftermarket radio, they usually have their own dedicated fuse on the radio chassis; unplug the wiring harness to access it. These are usually what blows when the vehicle is jumped and too much current is seen.
How do you turn off the stereo in a jeep?
“That little quirk goes along with a nastier one. In the past, one shut off the stereo by pushing a button in the volume knob. Now, Jeep says you are not shutting off the stereo, just muting it (though the amplifier still shuts down); so when you turn your car back on, the stereo blasts back out again.
What do I need to upgrade my Jeep radio?
You’ll need a mounting kit to trim out the new radio, a wiring harness that allows you to connect it without cutting the factory wiring, and an antenna adapter that connects your Jeep’s antenna to the new radio.
Where is the factory radio on a Jeep Wrangler?
An easy way to see if your factory radio (09 Wrangler) powers up (assuming fuses are good) is to remove the dash as depicted in the video below. After this, pull the plugs from the back and remove radio.
There will not be a reset button unless it is an aftermarket stereo. Also, if it is an aftermarket radio, they usually have their own dedicated fuse on the radio chassis; unplug the wiring harness to access it. These are usually what blows when the vehicle is jumped and too much current is seen.
Why is my Jeep Wrangler X not working?
I have a 2009 Wrangler X that wasn’t started for a few weeks. I ended up jumping it with another vehicle and the lights and windshield wipers wouldn’t stop working. I ended up shutting down the vehicle, and disconnecting the battery to reset these items (which are now working). This is when I noticed the radio was not working.