How do you remove a front wheel axle?
Axle Removal. Remove brake caliper (s). These will be fastened to the forks with 12mm bolts. After removing the bolts lift the caliper (s) off the disk and tie the caliper up to some part of the frame/fender so there’s no tension on the brake hose. This is the best possible time to inspect your brake pads.
What’s the best way to replace a CV axle?
– Coat contact surface of twelve-point nut with oil and screw on as far as possible. – Pull outer joint into wheel hub until outer joint is in position. – Connect ball joint to control arm. – Use new bolts. – Align bolts to markings. Use new bolts! Use new bolts! – Lower vehicle until wheels touch ground.
How to remove a front wheel bearing Assy?
There are 2 loctited 21mm head bolts that hold the brake caliper frame to the axle support. THESE ARE TIGHT!!! Rotate the steering to get to them easier. Remove the bottom, then loosen the top one so you can remove it with your fingers. You will need to have something ready to support it when you remove the brake assy. Step 5:
What kind of bolt is used to remove an axle?
The inner part which is bolted to the transmission most likely uses what is called a triple square spline type tool. It is similar to a torx type bolt, but has more splines, Now, here are the directions specific to removing the axle.
What’s the best way to change an axle?
By this time, you can put the wheel back on the vehicle (again, the same as you would when changing a tire). After the wheel is on, you can lower the car off the jack and jack stands. Tighten the axle nut. Finally, you can retighten the axle nut once the vehicle is back on the ground.
How do you remove a wheel from a CV axle?
Tape the steering knuckle joint with a hammer (hitting the knuckle where the rod goes through and not the threaded portion of the tie rod) to help remove it. Unbolt the hub from the strut tower. Two more 17mm bolts will connect the wheel hub to the strut tower.
What to do if your CV axle nut is stuck?
You will need to use pliers to straighten the two bent ends of the cotter pin before you can remove it. If the pin is stuck, try spraying it the a penetrating lubricant from a hardware or automotive store. The lubricant should actually help with the axle nut as well. Remove the axle nut. Once the cotter pin is out, you can remove the axle nut.
Can you remove axle nut before jacking up car?
Remove the axle nut. Once the cotter pin is out, you can remove the axle nut. The nut will take significant torque to remove, which is why it is much safer to remove the nut before jacking up the vehicle. Unfortunately, axle nuts do not have a standard size, and the socket size required will be different for different vehicles.