How do you remove a front spring?
- Step 1: Get the Front End in the Air. Park the car on a flat and level surface.
- Step 2: Remove the Shocks. The shocks mount at the top and bottom.
- Step 3: Compress the Coil Spring.
- Step 4: Loosen and Remove the Ball Joint Studs.
- Step 5: Remove the Spindle/Steering Knuckle Assembly.
Can you replace one coil spring?
It’s recommended to replace coil springs in pairs. Over time coil springs weaken, so if you replace only one spring, the left and right springs will respond differently to the road and the left and ride sides may have a different ride height. We don’t recommend replacing coil springs DIY, because it’s not safe.
How do you put a new spring in?
The top coil of the new spring may be different in shape from the bottom coil. Be sure you insert it right side up. Compress the new spring with the spring compressor clamps, and place it on the lower wishbone. Make sure the bottom of the spring is seated properly.
How do you change coil springs on a car?
Check the rating with your local dealer. Springs are normally identified by coloured paint markings. Raise the car with a jack, and support it on axle stands beneath the frame . Apply the handbrake securely and chock the rear wheels. Remove the raised wheel. Use a ball-joint separator to split the joint.
Where can I get new springs for my car?
It is also best to replace both front springs — the other one may not match exactly the rating of the new spring to be fitted. Check the rating with your local dealer. Springs are normally identified by coloured paint markings.
How do you remove springs from a BMW?
To remove the struts, you will need to put the front end of the car on jack stands, requiring a big floor jack and two jack stands, and an 18 mm socket on a long wrench. To remove the springs, you will need a GOOD spring compressor and an 18 mm socket on an impact wrench (air or electric).
How to replace coil springs in front of car?
Steps to Replace Front Coil Springs 1 Loosen the lug nuts, then raise the front of the vehicle using a jack. Secure it with jack stands, and then remove the lug nuts and wheels.
What’s the best way to replace a suspension spring?
Move the lower control arm down until the spring is completely loose. Remove the spring from the vehicle. Step 7: Remove the old strut or shock. Since you’re replacing the spring, it’s a good idea to replace the strut or shock at the same time. Although this step is not required, it’s recommended by most manufacturers and ASE certified mechanics.
How do you replace a leaf spring on a car?
Attach the spring to the rear bracket. Fit the other end of the spring in the square-shaped bracket at the back end of the wheel. Replace the eye bolts and nuts, tightening them until the spring is suspended in place. Install the U-bolts and shock pad. Hang the U-bolts over the axle, 1 on each side of the spring.
Where do you attach a spring to a car?
You’ll notice that the spring is attached to the lower control arm and a top bushing mount on the body. Step 3: Raise the vehicle. It’s recommended to work on one wheel at a time when completing this project, but you can raise the entire rear end and place the car on jack stands.