How do you read a scanner code on a car?

How do you read a scanner code on a car?

1. How to read OBD codes: Preparation.
2. Step 1: Plug the OBD scanner into the OBD port.
3. Step 2: Turn on the ignition.
4. Step 3: Enter the Vehicle Identification Number.
5. Step 4: Find OBD codes in the menu.
6. Step 5: Interpret the first character of the OBD code.
7. Step 6: Interpret the second character of the OBD code.

What does the Check Engine light on a Nissan Sentra mean?

When the check engine light illuminates on the dash in a Nissan Sentra, it is an indication that the computer has recognized a problem within its sphere of influence. Once the problem has been addressed and corrective action completed, the computer can be reset by erasing the existing codes.

How to reset the computer on a Nissan Sentra?

Once the problem has been addressed and corrective action completed, the computer can be reset by erasing the existing codes. Insert the code scanner’s connector into the OBD port located under the dash to the right of the steering column. Turn the ignition key to the run position. Make sure the engine is off.

Where to find Nissan check engine light codes?

These are listed in numerical order for easy searching. When retrieving Nissan check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.

How to read engine OBDII Codes without Nissan scan tool?

In this way, all the detected malfunctions are classified by their DTC numbers. The DTC 0000 refers to no malfunction. How to read the engine codes without a Nissan CONSULT or scan tool. (Set ECM in Diagnostic Test Mode II) Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.

In this way, all the detected malfunctions are classified by their DTC numbers. The DTC 0000 refers to no malfunction. How to read the engine codes without a Nissan CONSULT or scan tool. (Set ECM in Diagnostic Test Mode II) Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.

Do You need A post repair scan on a Nissan?

However, Nissan/INFINITI has added that all vehicles 2008 and newer are required to have a post-repair scan. Also, 1996-2007 model year vehicles are recomended to have a post-repair scan.

When do I need A post repair scan on my Infiniti?

Figure 2 – INFINITI Pre- And Post-Repair Scanning Position Statement. However, Nissan/INFINITI has added that all vehicles 2008 and newer are required to have a post-repair scan. Also, 1996-2007 model year vehicles are recomended to have a post-repair scan.

How to find the service engine soon code?

Once the ECM is in Diagnostic Test Mode II, the “Service Engine Soon” warning light will start flashing. Count to flashes to determine the code A particular trouble code can be identified by the number of four-digit numeral flashes. The ‘zero’ is indicated by the number of ten flashes.