How do you measure trailing arm bushings?
Common signs include a clunking noise when you accelerate or brake, excessive and uneven wear on tires, and loose steering when turning corners.
Are Civic and Integra trailing arms the same?
94-01 integras, 88-00 civics all have the same trailing arm (yes ITR and CTR too). the 90-93 integras used the same but the bushings were not the same. It’s best to answer this question by how they differ. While the trailing arms might be the same or similar dimension, be mindful of the spindle that’s attached to it.
What is trailing arm bushing?
The trailing arm bushings join the axle and pivot point on the body of the vehicle. The purpose of the trailing arm bushings is to cushion the movement of the suspension while holding the wheel on the correct axis. The bushings absorb minor vibrations, shocks, and noise from the road to make for a smoother drive.
Are trailing arms and control arms the same?
For the rear of a vehicle with a solid axle, any style of control arms might be used to connect the rear axle to the frame or unibody. Most often, it is three or four control arms with rubber bushings on each end. These control arms are called “trailing arms” or “rear trailing arms”.
What’s the size of a rear trailing arm bushing?
The small diameter bushing is part number 52385-SR3-000. It’s outside diameter is 3.170 inches. The large diameter bushing is part number 52385-SK7-N02. It’s outside diameter is 3.352 inches. So, here is the trick; I’m not going to say what fits what (and I have my reasons)!! Before you buy bushings, measure the old ones and order the correct ones.
How do you change the bushing on a Honda Dremel?
I used a round sanding drum on a Dremel. In the first method, you remove the complete Integra bushing from the arm. Burn out the rubber and sand the inside clean. Sand off the paint from the new Honda (Mugen) bushing. Coat the outside of the new bushing and (using a press), press it into the Integra shell.
When did Honda start replacing the bushings on their cars?
The reason that the bushings are now available from Honda is that they realized the marginal nature and released Service Bulletin 00-006 (dated December 11, 2001) authorizing the replacement of damaged bushings.
How does the trailing arm work on a car?
Due to the upper and lower control arms (that are mounted inboard of the trailing arm), the wheel actually moves in and out (away from the body). Due to the fact that the arms are different in length, the camber changes as the wheel moves up and down. This motion causes the trailing arm to rotate, as viewed from the rear of the car.
How do you change the bushing on a Honda rear trailing arm?
In the first method, you remove the complete Integra bushing from the arm. Burn out the rubber and sand the inside clean. Sand off the paint from the new Honda (Mugen) bushing. Coat the outside of the new bushing and (using a press), press it into the Integra shell.
How to Mount trailing arm bushing tool safely?
Hook design for mounting the tool on the trailing arm securely without damaging the ABS sensor cable, trailing arm, and parts close to the bush with a hydraulic press or disconnect brake parts such as calipers, rotors, brake shoes, brake fluid lines, or emergency brake cables
I used a round sanding drum on a Dremel. In the first method, you remove the complete Integra bushing from the arm. Burn out the rubber and sand the inside clean. Sand off the paint from the new Honda (Mugen) bushing. Coat the outside of the new bushing and (using a press), press it into the Integra shell.
The reason that the bushings are now available from Honda is that they realized the marginal nature and released Service Bulletin 00-006 (dated December 11, 2001) authorizing the replacement of damaged bushings.