How do you manually adjust LCI leveling?
How to Enter Manual Mode – Extend:
- Push “ON/OFF” to turn the system on.
- Push the “UP” arrow once, or until the screen reads “MANUAL MODE”.
- Push the “ENTER” button once.
- Push the “FRONT” button to extend the front landing gear legs.
- Push the “REAR” button to extend the middle and rear landing gear legs.
How do I manually level my RV?
How To Manually Level Your Towable RV
- Use Your Bubble Level. As you are pulling into your campsite, try to get as close as possible to being level left to right.
- Go Up On Blocks. If you’re not level, grab your set of blocks.
- Chock Your Wheels.
- Unhitch.
- Use Your Bubble Level.
- Adjust the Jack.
- Stabilize.
How do I reset my LCI panel?
If an issue involving the system occurs, the TOUCH PAD will register an ERROR MODE alert, indicated by the “LCI LOGO” and the “LEFT” and “RIGHT” arrow lights flashing. Operator must press “ON/OFF” button to reset operation.
How do you reset error on LCI electronic leveling?
We have heard of this issue before on the Lippert Ground Control systems # LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin retracting. All of the jacks should fully retract and clear the error.
How does the LCI automatic leveling system work?
Coach must be running for LCI Electronic Leveling System to operate. Push ON/OFF button on Control Panel. The system is now operational and the electronic level lights will become active. Check to see that the Control Pad ENGAGE PARK BRAKE is engaged. Push the AUTO LEVEL button to begin the automatic leveling cycle.
How does the Lippert electronic leveling system work?
The Lippert Electronic Leveling System is an electric/hydraulic system. A 12V DC electric motor drives a hydraulic pump thatmoves fluid through a system of hoses, fittings and jacks to level and stabilize the coach. The Lippert Electronic Leveling System is totally integrated into the chassis of the coach at the manufacturer.
How do you set a zero point on a LCI?
To set the zero point (controller module must be fully secured in production intent location), first run a manual leveling sequenceto get the vehicle to the desired level point. Then activate the Level Zero point configuration mode. This mode is enabled by performing the following sequence: Turn panel off. Then turn panel on.