How do you install a rear spoiler on a Honda Civic?
Before you start, make sure the spoiler you chose will fit on the trunk of the car. Open the trunk and look at the lid. You should see two marks on either side of the lid. These are the four points you need to drill. If your spoiler comes with brake lights, you’ll need a fifth hole for the brake light harness.
How do you install a spoiler on a Honda Accord?
Install the new trunk spring. Use a flat head screwdriver to pry off the trunk lid’s rear trim panel. Then, remove the trunk side floor panel. Route the wire harness through the trunk lid holes. Secure the harness to the trunk hinges with zip ties. Connect the harness to the brake light plug.
How do you mount a spoiler on a car?
Smear some cleaning putty onto the drill holes. Line up the spoiler over the mounting bolt holes. Snake the spoiler’s wire harness through the 10mm hole. Position the spoiler directly onto the trunk lid, so the mounting’s bolt holes line up with the spoiler’s bolt holes. Fasten three 8mm bolts to the spoiler. Tighten the bolts to a snug fit.
Where to put rear spoiler on 71 Mustang?
If you want to install a rear spoiler on your 71 Mustang decklid, below are measurements taken on a decklid with a factory spoiler installation. Measurements of the location of the factory holes are shown in the photo at left and center left. The holes are centered 6 1/4″ inboard of the decklid side edge on both sides.
Where to drill hole for rear spoiler on Honda Accord?
Drill an 8mm hole through the mark closer to the rear windshield. This hole is for an additional mounting bolt. Drill a 10mm hole through the mark closer to the rear of the trunk lid. This hole is for the wire harness. Figure 3.
Where is the rear spoiler on a Honda Civic?
Pull the spoiler’s electrical harness all through the hole, and then route it through the rear tray panel past the cargo light tray until it reaches the brake light. Disconnect the brake light, and connect the spoiler lights to the 2-pin terminal.
Smear some cleaning putty onto the drill holes. Line up the spoiler over the mounting bolt holes. Snake the spoiler’s wire harness through the 10mm hole. Position the spoiler directly onto the trunk lid, so the mounting’s bolt holes line up with the spoiler’s bolt holes. Fasten three 8mm bolts to the spoiler. Tighten the bolts to a snug fit.
Why do you need a spoiler on a Honda Accord?
A spoiler would be a sleek accessory to your Honda Accord’s trunk. Not only will it give your vehicle a more aggressive flair, but for applications on the track, it can provide the added downforce to supplement traction and handling. There’s a wide variety of aftermarket spoilers available for the Honda Accord,…