How do you fix a drum break on a Chevy Silverado?
Adjust the brake shoes upward so the drum cannot complete a full revolution of spinning on its own (or half a revolution, if desired). Repeat this procedure for the other side. Carefully get into the vehicle and apply the brake pedal and parking brake mechanism simultaneously. This will center the shoes and integrate the parking brake mechanism.
How do you replace the brakes on a 1998 GMC Sierra?
Replacing the brakes on the 1998 GMC Sierra is a relatively easy task. Open the Sierra’s hood and remove approximately half of the fluid from the brake master cylinder using a turkey baster. Place this fluid in a clean container for reuse. Loosen the front lug nuts with a ratchet and socket, but don’t remove them yet.
How do you adjust the rear drum break?
Go back and use the spoon to turn the star wheel in the opposite direction. Occasionally, between making adjustments, yank on the parking brake cable near the rear of the backing plate to center the shoes. Continually check the tension of the shoes against the drum by spinning the drum (every four to five turns of the star wheel).
What should I do if my brake drum is leaking?
If there is a leak in the hydraulic system, you may notice fluid inside the drum and on the brake shoes. Usually, this is accompanied by decreased brake performance. If necessary, replace the leaky wheel cylinder. Loosen the brake line connected to it, then loosen the bolts at the rear of the cylinder.
Adjust the brake shoes upward so the drum cannot complete a full revolution of spinning on its own (or half a revolution, if desired). Repeat this procedure for the other side. Carefully get into the vehicle and apply the brake pedal and parking brake mechanism simultaneously. This will center the shoes and integrate the parking brake mechanism.
What are the brakes on a GMC Sierra?
Hey all, I have a 2006 GMC Sierra 1500 4×4. I recently changed the rear brakes, since changing them the brake pedal seems “soft” and the e-brake doesnt grab like it used to. A friend of mine said the rear brakes are self adjusting but its been a few days and still the same. Any info. will be greatly appreciated.
Go back and use the spoon to turn the star wheel in the opposite direction. Occasionally, between making adjustments, yank on the parking brake cable near the rear of the backing plate to center the shoes. Continually check the tension of the shoes against the drum by spinning the drum (every four to five turns of the star wheel).
Do you need to relubricate rear drum adjustors?
It is a good idea to clean and relubricate the adjustors, they fill up with dust and rust. They do self adjust, but you need to get them as close as possible when you install the shoes. If there is a large gap, the brakes will have a soft pedal and the E brake will suffer. The brakes only self adjust to the point of keeping up with pad wear.
What happens when one brake is stuck on a GMC Sierra?
Pulling to one side – When one brake is stuck (particularly a front brake) the whole vehicle will pull in the direction of the bad brake. So if it is on the passenger side, your Sierra will feel like it is steering in that direction.
How can I Fix my rear drum break?
You need to back up repeatedly and apply brakes firmly while backing up. That should do the trick. Remove the hub caps from the rear wheels and break the lug nuts loose with the lug wrench. Lift the rear of the vehicle with the floor jack and secure it onto the jack stands.
It is a good idea to clean and relubricate the adjustors, they fill up with dust and rust. They do self adjust, but you need to get them as close as possible when you install the shoes. If there is a large gap, the brakes will have a soft pedal and the E brake will suffer. The brakes only self adjust to the point of keeping up with pad wear.
You need to back up repeatedly and apply brakes firmly while backing up. That should do the trick. Remove the hub caps from the rear wheels and break the lug nuts loose with the lug wrench. Lift the rear of the vehicle with the floor jack and secure it onto the jack stands.