How do you drain crankcase oil?
Draining the oil The old oil should be drained with the engine warm, so that it flows more freely, taking with it any harmful deposits. Run the engine for a few minutes, then switch off and put a drain can or container big enough to hold all the engine oil under the sump drain plug.
How do you drain a Harley Davidson crank case?
Thanks in advance for any and all suggestions. Pull the cam cover, it will drain all except a few oz in the actual crank area. Take # 25 off, disable ignition , turn engine over with starter, the oil will spray out, clamp off the oil feed line from the oil tank first. Be careful when you put the plug back in it cross threads easy.
How do you change the oil in a Heritage Softail?
Unscrew the drain plug with a 5/8-inch socket and a socket wrench, or loosen the drain hose clamp with a flat-head screwdriver and pull out the hose plug. Allow your Heritage Softail’s oil to drain for a minimum of five minutes or until the flow of oil slows to a thin trickle.
Where is the drain plug on a Harley Davidson Dyna?
Dyna and Touring models have their oil drain plugs under the transmission housing. Drain the engine oil into an oil pan. Replace the drain plug’s O-ring, then screw it into place after the oil has drained. Tighten the drain plug to 18 foot-pounds with a torque wrench.
Why is oil draining out of my crank case?
In the past it has always cleared itself by dumping out (all over the engine) through the crankcase vent, but this time there is enough oil in the crank case that the starter cannot turn the motor to fire up. Any suggestions short of pulling the motor, removing the jugs and turning it upside down? Thanks in advance for any and all suggestions.
Thanks in advance for any and all suggestions. Pull the cam cover, it will drain all except a few oz in the actual crank area. Take # 25 off, disable ignition , turn engine over with starter, the oil will spray out, clamp off the oil feed line from the oil tank first. Be careful when you put the plug back in it cross threads easy.
Why did I remove the plug from my crank case?
The only concern in reinstalling the pipe plug is over-tightening it and cracking the case by mistake. If that had happened though, it is very likely that oil would be coming out of that area of the case pretty seriously.
Can a drain plug be installed wrong on a Harley Davidson?
Harley drain plug installation is not difficult but things can quickly become difficult if a drain plug is installed incorrectly. If a drain plug is not installed straight or is installed dirty, the plug’s threaded allocation in the case can become permanently damaged.
In the past it has always cleared itself by dumping out (all over the engine) through the crankcase vent, but this time there is enough oil in the crank case that the starter cannot turn the motor to fire up. Any suggestions short of pulling the motor, removing the jugs and turning it upside down? Thanks in advance for any and all suggestions.