How do you do a BMW Obdii drive cycle for smog check?

How do you do a BMW Obdii drive cycle for smog check?

1. Step 1: Cold Start. The engine coolant temperature must be below 50°C/122°F and above 6°C/11°F of the ambient air temperature during startup.
2. Step 2: Idle.
3. Step 3: Accelerate.
4. Step 4: Maintain Steady Speed.
5. Step 5: Decelerate.
6. Step 6: Accelerate Again.
7. Step 7: Maintain Steady Speed Again.
8. Step 8: Decelerate.

How do you do a smog drive cycle?

General Motors Drive Cycle For Smog Check

1. Start the vehicle from a cold start.
2. Let the engine run on idle.
3. Accelerate to 55 mph.
4. Hold a steady speed of 55 mph for 3 minutes.
5. Let go of the accelerator and coast until the vehicle hits 20mph.
6. Accelerate again until 60 mph.
7. Hold steady for 5 minutes at 60mph for 5 minutes.

How to complete a drive cycle and pass emissions and smog test?

1. Ensure that the fuel tank is between 1/4 and 3/4 full 2. Start cold (below 86 F/ 30 C) and warm up until engine coolant temperature is at least 160 F (typically one to three minutes). 3. Accelerate to 40-55 MPH at 25% throttle and maintain speed for five minutes. (Coolant must reach 190 F or more). 4.

How do you pass the smog test in California?

Without these required Emission Monitors your vehicle can not pass the smog test. You will be required to drive between 100-200 miles and over the course of a week, called a Drive Cycle, in order to “complete” the emission monitors and be allowed to pass the smog check.

How to pass inspection and complete a drive cycle?

If you have a Code Scout 700 http://amzn.to/Nnwvot you can get a reading that tells you how many monitors are ready and how many are incomplete. All 8 monitors need to be in a “ready” status before you can pass inspection.

How to test a Mercedes-Benz smog test?

• Start engine and accelerate engine speed to 1400 rpm. • Allow engine to run with increased rpms for 7 minutes (or drive the vehicle for 7 minutes). Park position and allow engine to idle (with no load) for 6 seconds. Do not use A/C. • After this step turn the ignition OFF, wait ten seconds and repeat this test step.