How do you clear codes on a Miata?
So to clear a code on your Miata, disconnect the negative battery cable (in the trunk) and leave the car sit for 60 seconds. Reconnect the cable, start the car and drive it for 10-15 minutes. If the check engine light comes on again, then there is a problem.
How big is the cooling system on a Mazda Miata?
The cooling system capacity is 6.3 U.S. quarts. Mazda s recommended anti-freeze solutions for the Miata are as follows: Remember that the primary task of liquid cooling is to transfer heat energy from the metal parts of the engine to the radiator and then to the air.
Which is the correct code for a Mazda check engine light?
1 Refer to our Generic OBD II code list for definitions on all other Mazda diagnostic trouble codes. 2 Manufacturer Specific Codes 3 P1000 4 P1001 5 P1100 6 P1101 7 P1102 8 P1103 9 P1110 10 P1112 11 P1113 12 P1114 13 P1116 14 P1117 15 P1120 16 P1121 17 P1122 18 P1123 19 P1124 20 P1125
What is the boiling point of water in a Miata?
The boiling point of water at 14.7 psia is 212¡F, and if the pressure is increased, it rises. The pressure in the Miata cooling system should be between 11 and 15 psi (25.7 to 29.7 psia) maximum, which would place the boiling point of a 50/50 coolant mixture at around 265¡F (at 15 psi) according to the Prestone labels.
Where are the fans on a Mazda Miata?
If A/C is installed, there is a second fan on the right side of the radiator called by Mazda the ÒA/C Condenser Fan.Ó The A/C fan motor is smaller and the fan shroud fits on differently spaced mounting points, so the two fans are notinterchangeable.
Where to find check engine light code on Mazda?
When retrieving Mazda check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
What causes a check engine light on a Miata?
This is done by opening and closing an EGR valve. The Miata’s computer calls for the valve to open and close based on a number of factors. If the computer senses that this is not being done properly (valve stuck open or closed or lines plugged), then the CEL is turned on.
What causes the cel to turn on on a Miata?
The Miata’s computer calls for the valve to open and close based on a number of factors. If the computer senses that this is not being done properly (valve stuck open or closed or lines plugged), then the CEL is turned on.
What is the trouble code on a Mazda 3?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Mazda diagnostic trouble codes. Manufacturer Specific Codes P1000OBD II Monitor Testing Not Completed