How do you check the transmission fluid on a 2001 Honda Odyssey?

How do you check the transmission fluid on a 2001 Honda Odyssey?

Unlike most vehicles this transmission is checked with the engine off. With the van on a level surface remove the dipstick (Yellow Handle) and wipe it off. Replace the dipstick in the dipstick tube and remove it. The fluid should be between the upper and lower mark.

Which year Honda Odyssey has transmission problems?

The 2002 to 2004 Honda Odyssey is the biggest culprit when it comes to transmission problems. This year, the company redesigned the transmission on the car, adding a fifth gear and lowering the gear ratios of the first four.

Where is the drain plug on a Honda Odyssey?

The picture of the transmission is for a ?-2004 Odyssey (second generation?). The third generation (2005, 2006, possibly all the way to 2010) has the drain plug on the other side of the transmission. Most second generation transmissions had an “oil jet” recall that places a tube down the fill hole to help lubricate gears or clutch plates.

Where to put the transmission fluid in a Honda Odyssey?

Place a drain pan underneath drain plug to catch the old fluid. You will find the drain hole behind the plastic shroud behind the front bumper. Make sure to allow for the draining oil’s trajectory, since it will at first flow out rather quickly.

How do you check the transmission fluid level on a 2001 Honda?

The fluid should be between the upper and lower mark. If it is below the lower mark pour fluid into the filler hole at the top of the trans till it is at the proper level. Use only Honda ATF-Z1 transmission fluid. Here is an image of dipstick location, and here is an image of filler hole location.

How do you change the crush washer on a Honda Odyssey?

The manufacturer and some aftermarket service manuals recommend always changing the aluminum crush washer with each change to prevent leaks. These can be purchased from your Honda dealer if you desire to replace them. Tighten the drain plug snuggly and remove tools and the drain pan from underneath the vehicle.

The picture of the transmission is for a ?-2004 Odyssey (second generation?). The third generation (2005, 2006, possibly all the way to 2010) has the drain plug on the other side of the transmission. Most second generation transmissions had an “oil jet” recall that places a tube down the fill hole to help lubricate gears or clutch plates.

Place a drain pan underneath drain plug to catch the old fluid. You will find the drain hole behind the plastic shroud behind the front bumper. Make sure to allow for the draining oil’s trajectory, since it will at first flow out rather quickly.

The manufacturer and some aftermarket service manuals recommend always changing the aluminum crush washer with each change to prevent leaks. These can be purchased from your Honda dealer if you desire to replace them. Tighten the drain plug snuggly and remove tools and the drain pan from underneath the vehicle.

The fluid should be between the upper and lower mark. If it is below the lower mark pour fluid into the filler hole at the top of the trans till it is at the proper level. Use only Honda ATF-Z1 transmission fluid. Here is an image of dipstick location, and here is an image of filler hole location.

How do you replace transmission fluid in a car?

Steps Purchase the replacement transmission fluid. Jack up the vehicle using the lift point on the driver’s side behind the front wheel. Place a drain pan underneath drain plug to catch the old fluid. Remove the transmission drain plug using a 3⁄ 8 inch (1.0 cm) ratchet. Allow all the fluid that will to drain from the transmission.