How do you check the transmission fluid in a Jeep TJ?
Steps On How to Check Transmission Fluid
- When you’re learning how to check transmission fluid, start by turning the car on.
- Begin looking for the transmission fluid dipstick.
- Once the dipstick has been located, remove it and touch a bit of fluid.
- Wipe the dipstick clean with a rag, and reinsert it back into the vehicle.
How to check the transmission fluid in a Jeep Wrangler?
With the transmission in Park and the parking brake set, run the engine at a fast idle for a minute, but don’t race it. With your foot on the brake, move the gear selector to each gear for a second, then back to Neutral (for the 2012 and later 5-speed NAG1 transmission, check the level in Park ). Check the fluid level.
What’s the best way to check your transmission fluid?
Insert long funnel into automatic transmission fluid dipstick hole. Carefully add automatic transmission fluid in small increments and recheck level each time until fluid level reaches “warm” line. CAUTION: DO NOT OVERFILL OR SPILL AUTOMATIC TRANSMISSION FLUID ON HOT ENGINE PARTS! Reinsert automatic transmission fluid dipstick fully. You’re done!
Where is the fluid drain on a Jeep Wrangler?
Note: On the Ultradrive 42RLE transmission, take notice of the pan bolt that has a sealant patch on it. Set aside this bolt for reuse and mark the bolt hole that you removed it from, typically the second from the front on the left side. Loosen the front pan bolts approximately one turn and fluid should start to drain from the rear of the pan
How often should I change my transmission fluid?
Check under the vehicle for transmission fluid leaks during the first few trips, and check the fluid level after a week. This video is a general overview of changing the transmission fluid on the typical vehicle.
Is it necessary to check transmission fluid in a Jeep Wrangler?
However, checking the transmission fluid in your Jeep Wrangler is an essential part of proper maintenance. If you let the transmission fluid in your vehicle get too low, it can cause major damage and could potentially result in a ruined transmission. Follow these steps to make sure your transmission fluid is at the proper level.
Where is the transmission dipstick on a 2004 Jeep Wrangler?
The engine in your 2004 Jeep Wrangler should be running when you perform a transmission fluid level check, otherwise it will be inaccurate. The video above shows where the transmission fluid dipstick is located in your Wrangler and how to check the transmission fluid level.
What causes a transmission leak in a Jeep Wrangler?
If you check it when it’s cold you will get a false reading from the dipstick. Here is more on the most common causes of a transmission leak: If your Jeep Wrangler’s transmission fluid levels are full, but you are experiencing these symptoms, you should pay attention to the color of your transmission fluid.
What to do if you have transmission fluid leak?
A transmission service technician will drain and replace the transmission fluid. While you are under your Jeep Wrangler, it’s a good time to check for other leaks, such as oil leaks or fluid escaping from the differential or the transfer case.