How do you check the oil on a Suzuki Boulevard s40?

How do you check the oil on a Suzuki Boulevard s40?

The dipstick is located on the left side of the bike when you are sitting on it, tucked just under the cylinder. Wipe the oil off the dipstick with a rag. Reinsert the dipstick in the block without tightening it. Pull the dipstick out and check the oil level according to the webbed portion.

How much oil does a Suzuki s40 take?

Suzuki Boulevard S40

1988 Suzuki LS650 Savage
Manufacturer Suzuki Motor Corporation
Weight 173 kg (381 lb) (wet)
Fuel capacity 10.5 L (2.3 imp gal; 2.8 US gal) (including 2.5 L of reserve)
Oil capacity 2.0 L (2.1 US qt) with filter change

What kind of oil does a Suzuki Boulevard s40 take?

SAE 10W-40 Motorcycle Oil, 1 Quart by Lucas Oil®.

How much oil does a Suzuki c50 take?

Oil capacity (oil change, no filter change): 3 litres. Oil capacity (oil change, with filter change): 3.4 litres.

How much oil does a Suzuki ls650 take?

***Kit includes 3 Quarts of Suzuki 4-Cycle Synthetic Racing Motorcycle oil, One OEM Suzuki oil Filter, and One Crush Washer. Formulated for air and water cooled engines.

What kind of oil does a 2006 Suzuki Boulevard C50 take?

20W-50 2006 Suzuki Boulevard C50 VL800 Engine Oil.

What type of oil does a Suzuki Boulevard take?

Suzuki ECSTAR R9000 10W-40 Full Synthetic Oil Change Kit for Suzuki Boulevard C50 VL800 2005-2009.

How do you check the oil on a Suzuki Intruder 1500?

oil level check. The oil filler is to the left of the clear lens oil check. The oil filter is under the battery, and the oil drain plug is toward the back underside of the engine.

What kind of oil to use on Suzuki DL650?

Thanks to Peter Hartikka for graciously loaning his bike for this series. 1. 2-3 liters of 10w40 oil (look for the small circular label on the back of the bottle; if it says “energy conserving,” it’s the wrong type for bikes; additives in the oil will make your clutch slip. If there’s no such text, it will be fine).

What’s the oil capacity on a Suzuki Strom?

Check the sight window as you fill, and listen to the number cast in the side of the engine case–2300 ml is the Strom’s estimated oil capacity. When the sight glass is completely full, put the cap back in and start up the bike, running it for a minute or so.

What kind of gasket does Suzuki DR650 use?

Overfilling the crankcase might aggravate the trouble, so take care to keep the oil level correct. In late 2003 Suzuki changed to a steel laminated gasket that took care of the issue. The steel gasket has a small tab with a rivet in it on the front right corner of the engine below the oil cooler.

How to change oil on Suzuki V-Strom DL650?

Set your oil pan beneath the drain bolt, put your gloves on, and get out your socket wrench and 17mm socket. Left is loose, right is tight; spin the oil bolt off counterclockwise, being careful to keep the bolt itself from falling into the oil, and leave it for a while to drain.

Overfilling the crankcase might aggravate the trouble, so take care to keep the oil level correct. In late 2003 Suzuki changed to a steel laminated gasket that took care of the issue. The steel gasket has a small tab with a rivet in it on the front right corner of the engine below the oil cooler.

What to do if your Suzuki DR650 clutch nut is loose?

While you have the clutch cover off it would be a good idea to check this nut for proper torque (72.5 ft lbs). The nut is a left handed thread. If you find the nut is loose on your machine you will want to check the condition of the key. If there is any side wear or grooving replace the key.

What’s the neutral indicator on a Suzuki DR650?

If you are planning on doing a valve adjustment crack the plug loose the night before. Neutral Sending Unit (NSU)- This is a sensor within the engine that lights the “Neutral” indicator on the dash. It is held in place by two screws.

What to do if your Suzuki Eiger does not start?

Check the oil, gas, transmission and brake fluid levels on the Suzuki Eiger. If there is not enough gas in the ATV, it will not start. Checking the fluids regularly to see if there are any leaks or if any of the fluids are dangerously low. Top up any fluids that may be low before you use the ATV.