How do you check the fuel pump pressure?
Start the engine and record the pressure reading. Tip: Check the manufacturer’s specifications on pressure testing the fuel pump. Many manufacturers recommend checking the pressure with the key on, with the engine running, and at a particular RPM. Step 8: Check for the appropriate pressure.
What happens when the check valve on a fuel pump fails?
If the check valve fails or is jammed open by fuel contamination, the hold pressure will leak down. If that happens while the engine is cold, the starter will crank a bit longer while the fuel pump builds enough pressure to start the engine.
How can you tell if your fuel pump is dead?
Of course, there could be other explanations for your engine’s failure to start besides a failed fuel pump. To confirm that your pump has failed, check the pressure in your fuel lines with a fuel pressure gauge; if it reads zero, then your pump is likely dead.
What to do if there is no fuel pressure?
If no fuel pressure is present, check the fuel pump relay and fuse in the PDC ( power distribution center .) If there is still no fuel pump operation access the fuel pump power feed wire, there are a few ways to do this, a wiring schematic will call out the color wire used to energize the fuel pump.
How much pressure should a fuel pump be putting out?
If the fuel pump does not meet the required pressure then the fuel pump may be failing. A typical, port-injected vehicle will require between 30 and 80 PSI . Vehicle specific fuel pressure specifications can be found in the factory repair manual.
How can I test the fuel pump?
Hook the pressure gauge to the fuel pump test fitting. Locate your fuel pump test point, which is usually near the fuel injectors, and locate the point at which the pump hooks up with the filter injector rail. There should be a separation joint or a test port, where the pressure gauge attaches.
How do you check mechanical fuel pump?
Checking Mechanical Fuel Pumps Remove the air cleaner. Visually inspect the pump. Another way to check the pump is disconnect the fuel line at the carburetor and place it in a container. You should also check fuel pump pressure.
How do I Check my fuel pressure?
How to Check Fuel Pressure. Most car models have a test port on the fuel injector rail for the testing of the pressure. If your car does not have it, check the manufacturer’s guideline. You may need to remove the fuel line and use an adaptor for the testing.