How do you change the brake light on a Mercedes SLK 230?
The switch will only fit one direction in the mounting bracket (arrow). Plug the brake light and ASR harnesses into the new switch. Depress the brake pedal while inserting the new switch to allow plunger clearance. Then spin the switch counter-clockwise until it seats in position.
What does Bas ESP ABS mean on a Mercedes Benz?
What does BAS ESP ABS light mean on a Mercedes-Benz? Let’s first take a look at what each of these acronyms means. BAS stands for Brake Assist System. It provides additional braking power in case of emergency situations.
How does the ABS module affect the brake pads?
The ABS module or in some models the SBC Brake module will apply pressure to the brake pads at each of the individual wheels depending on the directions it receives from the vehicle’s control units. While it is less likely to fail, it is known to be a problem as well. Replacing the ABS Module can be costly.
When to replace brake lights on a Mercedes?
If the taillights are still original, the dealership should replace them under warranty with the updated lights. Next is checking the brake light fuse in the under-dash fuse panel. If all these check out, the brake switch is possibly faulty. Even when the brake lights function properly, the brake switch’s ASR circuit can still be bad.
How to replace the brake pad on a BMW?
BMW Brake pad replace warning – YouTube If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: lrbBeH636v9vcMp5)
Why are my brake lights not working properly?
The switch actually has dual functions: It controls the brake lights and is also part of the ASR traction-control system. Non-illuminating brake lights can have a variety of causes. The obvious starting point is checking the bulbs to see if they’re burned out, then cleaning the contacts if the bulbs appear to be good.
Where is the brake light switch on a Mercedes Benz?
The brake light switch is located right above the brake pedal. To access it, remove the underside panel cover. Usually, the panel is held in place with 3 to 5 screws. Mercedes-Benz uses Torx head screws.
How do I reset the brake light switch?
Perform the BAS/ESP Reset Procedure – with the engine running and the steering wheel centered, turn the wheel all the way to the Left lock, then all the way to the Right lock, then back to center. Note this procedure relates to the battery disconnection, not because the brake switch was replaced. 6. Enter your radio code. 7.
Are there any recalls on Mercedes Benz brake lights?
Mercedes Benz issued an R170 taillight recall due to melting bulb sockets. If the taillights are still original, the dealership should replace them under warranty with the updated lights. Next is checking the brake light fuse in the under-dash fuse panel.
The switch will only fit one direction in the mounting bracket (arrow). Plug the brake light and ASR harnesses into the new switch. Depress the brake pedal while inserting the new switch to allow plunger clearance. Then spin the switch counter-clockwise until it seats in position.
The brake light switch is located right above the brake pedal. To access it, remove the underside panel cover. Usually, the panel is held in place with 3 to 5 screws. Mercedes-Benz uses Torx head screws.
What to do if your brake light switch is not working?
Try turning off the engine and remove the key, wait a few seconds and restart the car. That may solve the problem temporarily. Even though the problem could be multiple things, the brake stop light switch is the first thing you should inspect. Which Mercedes-Benz models are impacted by the defective brake light switch?
Can you remove the rear center console on a Mercedes SLK?
These photos show the necessary steps for removing the SLK’s rear center console. The shift-lever cover plate must be removed to access two screws. (See that article for details.) Some owners claim that the console can be finessed over the parking-brake lever with the rubber handle still in place. However, the manual recommends removing it.