How do you attach a splice to a tipm?
Solder the brass splice band clamp with rosin core solder. e. Slide the shrink tube evenly over the soldered brass splice and apply heat to the shrink tube until glue comes out of both ends of the shrink tube. 12. Carefully plug the 50-way electrical connector into the bottom of the TIPM.
Do you need cable clamps for nonmetallic junction boxes?
Although, in article 314.17 (C)’s exception, nonmetallic boxes have no cable clamps and must have cables supported within eight inches of the junction box. In either instance, the wire is secured by wire staples that keep it from moving within the wall cavity.
How to install a C Wire Adapter Module?
Your C-Wire Adapter Module comes pre-wired on the “EQUIP” side. Take note of these five wires (Red, Yellow, White, Blue, and Green): Strip approximately 1 cm of the sheathing off each wire; the sheathing should already be scored to conveniently expose the wire.
How do you connect a C Wire Adapter to a G Terminal?
Following the wiring diagram from above on the “EQUIPMENT” side, take the W-wire from the “EQUIP” side of the C-Wire Adapter Module, and connect it to the G terminal on the control panel. Once all wires are secured, replace the C-Wire Adapter Module’s cover, close the control panel door, and turn the power to the system back on.
Your C-Wire Adapter Module comes pre-wired on the “EQUIP” side. Take note of these five wires (Red, Yellow, White, Blue, and Green): Strip approximately 1 cm of the sheathing off each wire; the sheathing should already be scored to conveniently expose the wire.
Following the wiring diagram from above on the “EQUIPMENT” side, take the W-wire from the “EQUIP” side of the C-Wire Adapter Module, and connect it to the G terminal on the control panel. Once all wires are secured, replace the C-Wire Adapter Module’s cover, close the control panel door, and turn the power to the system back on.
Where does the Y wire go in a C Wire Adapter?
Insert your Y-wire into the top of the diode pair, and secure the set screw. Following the wiring diagram from above, the side of the diode pair labeled W should go into the W/E slot, and the Y side into the Y slot of the backing.
Where can I get ConMet danger Aler tindica decals?
ConMet Customer Service Call ConMet’s Customer Service at 1-800-547-9473. ConMet Decals The following decals are available upon request. Danger aler tindica es a hazardous situation which, if not avoided, will result in death or serious injury.