How do you adjust the idle on a fuel injected motorcycle?
On some fuel-injected motorcycles, there is a knob sticking out the side of your bike near the engine compartment. You can just turn this knob clockwise or counterclockwise to adjust the idle speed.
Can you adjust idle speed on fuel injected Harley Davidson?
When a bike possesses a carburetor, you can easily adjust idle speed according to your preference with an idle screw. But for an electronic fuel-injected motorbike, it is altogether a different process. Hence, many motorbikes riders face problems when it comes to fuel injection installed by Harley Davidson. But you don’t need to worry.
What causes the idle speed to go up or down?
The idle air control valve is programmed to regulate and maintain the engine idle speed at a constant rate. If the valve fails or has any issues it can cause the idle speed to be thrown off. This may result in an unusually high or low idle speed, or in some cases a surging idle speed that repeatedly climbs and falls. 2. Check Engine Light comes on
What’s the idle on a fuel injected motorbike?
Most Fuels injected motorbikes have high idle, which many motorbike riders dislike. In general, the Fuel-injected idle does not get altered as the manufacturing factory sets the appropriate idling and controls electronically in the EFI system.
How to adjust Cold idle with fuel injection?
Adjust the cold idle to about 1500 rpm’s. Turn the bike off; put it back together; and pull the ecm and fuel pump fuses for a few minutes (under the right side cover). You’re done. (after you replace the fuses) I had the same problem with my ’01 (MM efi) Road King Classic.
What should I do if my fuel injected Harley wont start?
On fuel injected models, make sure that you can hear the fuel pump cycle when switched to RUN. If not, check your fuses. As always, the best way to avoid being stranded with your Harley Davidson is to be diligent about your bike’s maintenance.
What to do if your Harley Idles down?
The bike would idle down and die when I stopped for a stop light. Took it to a non-Harley repair shop. The following parts were changed: Check Valve, Fuel Pump, Top Plate Gasket, Intake Seal 90-03BT/XL, Fuel Pressure Regulator, Idle Motor Kit, Autolite Plugs, HD Fuel Line, Check Valve again.
How to adjust idle speed with fuel injection?
I have an ’01 fuel infected Roadking. Last year I noticed that it rarely went into high speed idle when cold. By the end of the season it was idling low, around 700, 750 rpm. According to the manual I am supposed to hook up a diagnostic tool to a connector, find a voltage and make adjustments.
How to idle a 2012 Road Glide Ultra?
2012 Road Glide Ultra, Big Blue Pearl. HALL OF FAME – WEINER! Try this. Turn ignition switch to off. Turn kill switch to run. Rotate ignition switch from off to ignition. The yellow check engine will turn on for a few seconds then off. As soon as the light turns off turn ignition to off.