How do I stop my RX-8 from flooding?
Warming the engine prior to turning it off will help prevent future flooding. Once the engine starts, let it run to make sure the engine has warmed before turning it off. Purchase a battery with the highest cranking amp. Extra cranking power can keep your engine from flooding.
Are there any problems with the Mazda RX8 engine?
During 2004-2005, there were numerous reports of RX-8 engine failure. Soon, the reputation of the engines was beginning to take shape. It was basically an engine that could only last for many owners up to 30,000 miles. Many Mazda owners were experiencing issues such as power loss.
How do you warm up a Mazda RX8 engine?
You need to warm up the engine slowly, stay in low revs depending on outside temperature for at least 20 minutes. Beware you need to warm up the oil, and the gauge on your dash is the water temperature, which heats up a lot faster! After that, drive it like you stole it.
What causes wheel replacement signal on Mazda RX-8?
It also could be a sensor malfunction, a wire loose, or some other minute detail that is upsetting the complex computer of the Mazda RX-8. If you have installed aftermarket wheels with different sizes front to rear, that may cause a false sensor signal to the ECU, please look at Wheel Replacement guide.
When to replace the break pads on a Mazda RX-8?
As the car is driven break pads will eventually be worn down. When the break pads get too low they must be replaced. The stock RX-8 does not carry a spare tire, but instead has a “fix-a-flat” kit stored in the trunk.
When did the Mazda RX-8 come out?
This category covers 2004, 2005, 2006, 2007, 2008 Mazda RX-8 Troubleshooting models. Your guide to finding the problems with your Mazda RX-8 so you can effectively and efficiently resolve them.
How to troubleshoot a Mazda RX-8 engine problem?
The easiest way to solve this problem is by replacing the battery with a new one, please look at Battery Replacement Guide. The RX-8 engine runs very rich when it is first started, meaning as it warms up it it has a higher then normal amount of fuel in the engine.
It also could be a sensor malfunction, a wire loose, or some other minute detail that is upsetting the complex computer of the Mazda RX-8. If you have installed aftermarket wheels with different sizes front to rear, that may cause a false sensor signal to the ECU, please look at Wheel Replacement guide.
As the car is driven break pads will eventually be worn down. When the break pads get too low they must be replaced. The stock RX-8 does not carry a spare tire, but instead has a “fix-a-flat” kit stored in the trunk.