How do I speed up my ezgo gas golf cart?
One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.
How can I speed up my EZ Go golf cart?
Tighten the governor spring located in the engine of most golf carts to adjust your cart’s top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine. To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly.
Can you push start a gas golf cart?
Can you push start a gas golf cart? Pushing an electric golf cart is simple because it has a ‘free wheel’ system. If the golf cart is gas-powered, you simply need to put it in neutral, so that it becomes ‘free wheel’ and can be moved without being powered.
How to fix an EZGO golf cart that won’t start?
1 Check the wiring for any damage or corrosion. 2 If there are no damages or corrosion, then simply tighten the connection to the solenoid and try again. 3 If it still won’t start, most likely there is a problem with the battery. 4 When you start the EZGO golf cart, it should only drop a little.
Where is the engine located on an EZ GO golf cart?
You must begin by making sure that the engine is completely turned off. This step not only guarantees your safety but also ensures that no damage will be caused to your golf cart’s engine. Expose the engine which is located at the bottom of your EZ Go gas golf carts.
Are there any problems with the EZGO TXT?
Another thing you can check is make sure the engine starts cranking before the carb starts to open when you press the throttle. If needed adjust the throttle cable… According to Bob-O in 2004 and early 2005 EZGO had problems with their clutches. EZGO was replacing the clutches on these carts under warranty.
Why does my gas golf cart not start?
The reason why a Gas Golf Cart Clicks but won’t start is because the connector to and from the solenoid is either loose or corroded. Check the wiring for any damage or corrosion. If you find any then you’ll need to replace it. If there are no damages or corrosion, then simply tighten the connection to the solenoid and try again.
Where are the governors on an EZ GO golf cart?
Many manufacturers, including EZ Go, do not want consumers tampering with their engines, and have thus hidden the governors in the spark plug ignition. This is very difficult to adjust without ruining the engine, and should be left to trained professionals. How can I stop the choke cable from getting hot on my EZ-GO golf cart?
How do you adjust the engine on an EZ GO?
To adjust an EZ Go Cart Governor engine, start by removing the seat so that you can access the engine. Once the seat is off, remove the screws from the black plastic cover at the rear of the seat and then set the cover aside.
What’s the speed of an E Z GO golf cart?
If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it.