How do I reset my ecu 240sx?
Remove the passenger side kick panel and the phillips screw holding in the ecu. Pull it out and turn the side with the light towards you. Put you key in the ignition and turn to the accessory on position (just before starting position).
Do you need to remap your Nissan Pathfinder?
Please take a look at the recent Nissan remapped models: [Note: Nm = Newton metre, BHP = Brake Horse Power] Do you want to gain more power, torque and better MPG for your Nissan Pathfinder? Then look no further. Our Nissan performance chips and Nissan remapping via the OBD port will dramatically improve your car’s performance and improve your MPG!
Where is the ECU on a Nissan club?
To clear all check engine light codes you need to reset the ECU. In the driver’s foot well is where the computer is located behind the plastic piece by the gas pedal. Take your key and turn it to the on position. Look on the ECU, you should see a flathead screw on the driver’s side. Turn this flathead screw completely clockwise.
What should I do if my ECU light comes back on?
Drive the car for at least 10 miles for the ecu to learn, if there is a problem with your vehicle then the check engine light will come back on and you can analyze the fault code that the ECM throws. These codes will guide you towards the root of the problem and you can begin replacing parts to try to fix the issue.
When does the ECM set p0101 on a Nissan?
I found that ECM set P0101 only when my car starts an engine. ECM has never set confirmed or pending P0101 during driving. There was no exception for more than 10 samples. So, I conclude that there is no drivability issue and my car may need to reprogram the ECU according to TSB from nissan.
Where is the ECU located on a pathfinder?
The ECU is under your passenger’s side seat. You can gain access to it by simply sliding the seat all the way forward and removing the plastic cover from the ECU. You can also remove the seat if you want, it makes access a little easier.
What are the sensors on a Pathfinder Pathfinder?
11 Crank Angle Sensor/Camshaft Position Sensor. 12 Air Flow Meter/Mass Air Flow Sensor. 13 Engine Coolant Temperature Sensor. 14 Vehicle Speed Sensor. 21 Ignition Signal. 22 Fuel Pump.
When to turn off the red LED on a pathfinder?
If the RED LED stays off, the mixture is more than 5% rich. If the RED LED stays on, the mixture is more than 5% lean. If the RED LED stays on or off above 2000 RPM, complete the diagnostics before beginning repairs.
I found that ECM set P0101 only when my car starts an engine. ECM has never set confirmed or pending P0101 during driving. There was no exception for more than 10 samples. So, I conclude that there is no drivability issue and my car may need to reprogram the ECU according to TSB from nissan.