How do I reset my airbag light manually?
How to Reset an Airbag Light
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Why is my airbag light on in my Subaru?
About your Subaru Airbag Warning Lights If no passenger is detected, that airbag may not deploy. When this light is on, a problem has been detected with the airbags or the seat belt pretensioners. Since these systems are essential to your safety in a crash, it’s not a good idea to ignore these warning lights.
Can you reset a airbag sensor?
Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off. If it comes back on then the best thing to do is to take your car in for a diagnostics scan.
Does airbag light need to be reset?
Bad or Faulty Sensors We all know that sensors can trip or fail without reason. Because of this, the airbag lights can come on and fail to turn off. Your mechanic will need to check your sensors and reset your entire computer system.
How do I get the airbag light to turn off?
Turning off the airbag light yourself can save you a trip to your car dealer.
- Turn on the ignition switch with your car key.
- Wait for the airbag warning light to turn off.
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
What would cause the airbag light to come on?
The most common cause for the airbag light coming on is that the airbag system is deactivated or turned off. There may be an issue with the crash sensors or other airbag component. Alternatively, the sensor in the passenger seat that determines whether that airbag should be active or not may be faulty.
What should I do if my airbag light is on?
The best thing to do if your airbag light has come on is to take the vehicle to a mechanic right away. A mechanic can help you to deal with the airbag light by examining the system with the help of the car diagnostic internal system.
How can I Fix my Subaru airbag light?
Subaru Airbag Light Fix! – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
Do you clear trouble codes before resetting airbag light?
Do never clear the trouble codes before you fix the problem caused by the airbag light. Read the codes and get information about what can cause the problem and therefore continue the diagnosis. You should never just reset the airbag light without repairing the problem.
When does the air bag indicator light go on or off?
“Passenger Airbag” “On” and “Off” stay illuminating during the self test, when the air bag indicator light is on in the cluster. After the self test, the passenger indicator light should show either “off” or “on” depending on whether someone is in the seat.
How can I read the code on my airbag?
It is possible to read the code by using the diagnostic procedure in the service manual, whereby you plug the diagnostic connectors together and count the flashes of the airbag light. Alternately the code can be read by the dealer using their scanner. Once the code is known, the source of the problem can be identified.