How do I program my 2010 Subaru remote?

How do I program my 2010 Subaru remote?

2010 Subaru Forester

1. Enter Programming Mode – Step 1. CLOSE ALL doors, UNLOCK ALL doors.
2. Enter Programming Mode – Step 2. OPEN and CLOSE Driver’s door.
3. Enter Programming Mode – Step 3.
4. Enter Programming Mode – Step 4.
5. Enter Programming Mode – Step 5.
6. Program Remote.
7. Program Additional Remotes.
8. Exit Programming Mode.

How do you program a 2011 Subaru Outback key?

2011 Subaru Outback Keyless Entry Remote Fob Smart Key Programming Instructions

1. Sit in the driver’s seat, close all doors and the rear gate or trunk lid etc.
2. Open and close the driver’s door one time.
3. open and close the driver’s door once.
4. turn the ignition key from LOCK to ON 10 times within 15 seconds.

How do I pair my Subaru key fob?

Open and close the door, then press the lock/unlock button on the key fob. Pull the key from the ignition and listen for the chime. Open and close the door a final time. The key fob should start working in 5 seconds.

How do I remote start my 2020 Outback?

“To start the engine with remote engine start system, briefly press the lock button twice within 2 seconds, then press and hold the lock button for 3 seconds”.

Do you need remote start for Subaru Outback?

The remote start needs to be installed in your car (that is an available accessory). It’s not there by default on any trim.

How do you turn on a Subaru keyless remote?

Hold down the “UNLOCK” switch, pull the key out and re-insert it into the ignition switch at least 5 times within 10 seconds after performing step 2. 5. Open and close the driver’s door within 10 seconds after performing step 4. 6. When completed the turn signal lights flash New Battery

Where is the antenna on a Subaru Outback?

Subaru never updated the owner’s manual (this stuff has been in there since 2015). Interesting to note – the new system for the 2020, when installed, doesn’t have the window mounted antenna anymore. There is just one big module that is installed behind the glovebox.

How do you turn off the chirp on a Subaru remote?

Electronic chirp when lock/unlock with remote – To turn off chirp or to turn back on 1. Sit in the driver’s seat and shut all doors and the rear gate. 2. Press the “UNLOCK” power door lock switch. 3. Insert the key into the ignition switch. 4.