How do I know if my salt cell is working?
The easiest way to be certain if the chlorinator is working is to make sure the cell is clean by checking the needle or production lights on the chlorinator box. When operating, you should also see bubbles (hypochlorite gas) inside the chamber, producing what looks like cloudy water – that’s chlorine being created!
How do you reset a salt cell?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
What to do if chlorinator is not working?
Check for a tripped circuit breaker or GFCI outlet test button. Many salt chlorinators also have a fuse inside the cabinet, designed to blow in the event of power overload, or a lightning strike. 2. Check Water Flow: The Salt Cell needs a certain amount of water flow to operate effectively.
Why is my salt generator not producing chlorine?
Salinity. Chlorine generators need salt to produce chlorine and can’t do so if the amount of salt in the water is too low. The desired salinity level in a saltwater pool is between 2,500 and 3,500 ppm. If your salinity is below 2,500 ppm, the generator will not be able to produce chlorine.
What causes a salt cell to fail?
Salt cells fail for a few different reasons, the main reason being lack of proper maintenance. It is very important to check the cell regularly for excessive buildup. Use a cleaning kit designed for salt cells to keep the plates clear of buildup. Another common cause of salt cell failure is improper water balance.
How do I reset my Pentair Salt Cell?
Press and hold the “More” button for 3 seconds to enter system status mode. All the lights will scroll across the panel, and then go dark. Only the “Power”, “Cell”, “Life”, and “Low” lights will be lit.
How do you recalibrate a Hayward Salt Cell?
Turn Salt System Off and On With the pump running, take the power switch down to the “Off” position, and then back up to “Auto”. You should hear a click within 10 or 15 seconds. When you do, press the diagnostic button five times in a row. The system will go through a recalibration process.
How do I know if my salt cell needs replacing?
There are a couple of signs that are indicative of a cell that likely needs replacement: corroded or disconnected plates. Corroded plates can be cleaned, but if the cell still isn’t generating enough chlorine after cleaning, you’ll need to replace it.
What to do if your salt cell is not working?
Below are a few tips on how to deal with salt cells that don’t work. 1. Replace or repair damaged units immediately when problems are identified. 2. Replace the entire unit every once in a while. More often than not, a well maintained and high quality system should offer decent service for up to 5 years. 3.
Why are my salt cells not producing enough chlorine?
The easiest way to do this is to test your water balance regularly for the pH and chlorine levels. If the chlorine level is dropping it might mean your salt chlorine generator is not producing enough chlorine. Also, most system control units come with some kind of alert to notify you of low salt and chlorine levels.
How can I tell if my salt cell chlorinator is not working?
A simple way to check that power is on is to feel the power cord for warmth. If the control panel has no indicator lights, that’s a good sign of no power. Check for a tripped circuit breaker or GFCI outlet test button. Many salt chlorinators also have a fuse inside the cabinet, designed to blow in the event of power overload, or a lightning strike.
How does a salt cell work in a pool?
The salt cell is an electrolytic converter installed on the return line behind the filter, heater, and pump. When water passes through the cell, a low-level electrical charge converts dissolved salt into chlorine. The chlorinated water returns to the pool, where it kills bacteria and prevents algae growth.