How do I identify a Ford T10 transmission?
Look for casting identification on the transmission casing. According to Drivetrain.com, the “T10” designation and the code, “13-04,” is sometimes cast on the transmission housing. Count the cross-grooves on the input shaft. The input shaft enters the engine at the front of the transmission.
What vehicles came with a T10 transmission?
Ford installed it in their full-size models (both Ford and Mercury), Mustangs, Falcons, Comets and Fairlanes until ’65. AMC continued to use it in their Javelin and AMX cars until ’74.
What did a super T10 come in?
The Super T-10 was the upgraded version of the original T-10 transmission, which made its first appearance in a 1957 Chevrolet Corvette. The Super T-10 was installed in GM cars from 1974 to 1982.
How do I know what transmission I have 4 speed?
While it’s obvious that the four speed will use three shift-linkage arms and the three speed will have two, if the first letter is R, then you have found a four speed. If it starts with an S, you are looking at a three-speed Saginaw.
How do I know what Muncie transmission I have?
Another way to confirm that the transmission is original to your car is most Muncie four-speed transmissions will have a Vehicle Identification Number (VIN) number stamped on the main case. The engine and transmission were stamped at the same time by the final assembly plant.
How do I know if I have a TKO 600?
A regular TKO-600 will have a 0.64 fifth gear, in which case the input shaft would turn about 2/3 of a turn to one turn of the output. 64% of a turn. A close-ratio TKO-600 will have a 0.82 fifth gear, in which case the input would turn a little more than 3/4 of the way around for one turn. 82% of a turn.
Where is the transmission ID tag?
Find the transmission ID tag on the top surface of the transmission or under a servo bolts on the transmission.