How do I change the oil filter in my van?
- Keep the oil drain pan underneath the car and locate the oil filter.
- Loosen it with the filter wrench, turning it anticlockwise. Remove the oil filter by hand.
- Before installing the new oil filter, apply a little engine oil to the new gasket.
- Finally, install and tighten the new oil filter by hand.
What’s the best way to change an oil filter?
2. Put on protective gloves, open the bonnet, and remove the oil filler cap – this will help the oil drain more quickly. Then, on firm, level ground raise the car using a jack and secure it on axle stands. You will need to work underneath the car, so it’s vital that it is secure and safe.
How do you change the oil in a MerCruiser?
Replace the oil filter. Use the correct filter wrench and remove the old filter. Turn it counterclockwise as viewed from the bottom end of the filter. In some cases the filter might be difficult to remove. This is usually because it had been over-tightened when installed.
What happens when you don’t change the oil filter?
So when it’s time to change the oil, the filter will set you back a few extra dollars – but not changing it is just false economy. If you leave that old filter on, as soon as you start the engine and get it to operating temperature, that nice clean motor oil is soon going to be just as dirty as the oil you just drained out.
What kind of oil filter do I need for a MerCruiser?
There are two basic sizes of oil filters used depending on which model Mer cruiser engine you have. Most Mer cruisers use a standard Oil Filter Wrench. The only exception are some of the Mer cruiser V6 (4.3L) engines. If you have a V6 and the filter is threaded onto the block it should be a smaller diameter filter.
What does an engine oil and filter change include?
What does an Engine Oil and Filter Change include? A full oil change includes the following steps, to help maintain performance levels and protect the engine oil from contaminants that can build up over time: Engine oil drained ; Replacement sump plug washer ; Oil refill based on manufacturer’s recommendation. Replacement oil filter
So when it’s time to change the oil, the filter will set you back a few extra dollars – but not changing it is just false economy. If you leave that old filter on, as soon as you start the engine and get it to operating temperature, that nice clean motor oil is soon going to be just as dirty as the oil you just drained out.
What should I do for an engine oil change?
A full oil change includes the following steps, to help maintain performance levels and protect the engine oil from contaminants that can build up over time: 1 Engine oil drained 2 Replacement sump plug washer 3 Oil refill based on manufacturer’s recommendation. 4 Replacement oil filter More
When is the best time to change your oil filter?
As a result, the owners of large muscle cars or pickup trucks would rather have to change their oil and oil filter earlier when faced with severe conditions. It is essential to change your oil and filter when the service light is on, even if you know your oil is still at a good level and the engine isn’t at risk of failing from oil starvation.