How do I bypass the PassLock on a 2000 GMC Jimmy?
How do I Reset the Security System in a 2000 GMC Jimmy?
- Open the driver’s door.
- Press the power door-lock switch to lock all the doors, with the driver’s door still open. The “SECURITY” light will come on. Close the driver’s door. The “SECURITY” light will go off after about 30 seconds. The system has been reset.
How to bypass a gm PassLock system?
Thankfully this is an easy fix.
- Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
- Look at the dashboard and locate the theft system light.
- Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.
Is there a PassLock bypass for a GM car?
It replaces the ENTIRE core of the GM security system immobilizer in your car. FOREVER. One module that works for VATS, PassKey and Passlock on hundreds of GM car models and years, either with chip-keys or not and also when the TDM is embedded in other modules, like BCM or IPC or EVO and even if your car is not running at all.
How to bypass vats, Passkey and PassLock security systems in GM?
It can be VATS, Passkey or Passlock anti theft system that is going bad causing your issue. I am going to share a secrete with you on how you can bypass these systems with very little effort. This is a really unique security system bypass kit that you can use to override your current factory theft system on your GM vehicle.
How much does a PassLock bypass system cost?
It goes by many different names, like Passkey, VATS or Passlock etc. depending on the car manufacturer that is installing them and on a number of small variants. These systems only have 3 components, but those components together can cost you more than $1,000 at the dealer to replace. They are:
What’s the difference between General Motors Passkey and Passkey III?
PASSLock increased the level of security while retaining the ease of service and costs offered by standard ignition lock systems. Unlike the General Motors PASSKey I/II, VATS, PASSKey III, or keyless, the security of the PassLock system is built into the lock and is not dependent on a specialized key or separate device.
Can You disable the PassLock on a GM car?
The following instructions will allow you to disable the PassLock security in quite a few GM Vehicles. •This will allow you to install a remote starter and not have to purchase a bypass. •Avoid Costly repairs for an already broken PassLock System.
Why did General Motors start the PassLock system?
Aug 1st, 2005 The PassLock system was designed to prevent vehicle theft by disabling fuel to the engine if attempts are made to start the vehicle without the correct bitted key. PASSLock increased the level of security while retaining the ease of service and costs offered by standard ignition lock systems.
It can be VATS, Passkey or Passlock anti theft system that is going bad causing your issue. I am going to share a secrete with you on how you can bypass these systems with very little effort. This is a really unique security system bypass kit that you can use to override your current factory theft system on your GM vehicle.
How big is resistor on GM PassLock system?
If you can’t find something anywhere near to what you read on the ohm meter you have the option to use a resistor between 0.5K ohms up to 13.6K ohms.