How can I reduce the fuel consumption of my scooter?
DONT’S of fuel consumption:
- Do not keep the clutch lever hard-pressed when you are riding.
- Do not run the engine in low gear for prolonged time.
- Do not park your under direct sunlight as it leads to fuel vaporization.
- Do not keep brake pedal pressed when on the move.
- Do not increase the engine rpm through traffic stops.
Where is the Kill Switch on an electric scooter?
Most scooters have four things that need to be done before they can be started with the electric starter: The kill switch (usually near the right grip) has to be in the “on” position The rear (left) brake lever has to be squeezed. The starter button must be pressed. Some scooters may have other interlocks on the front brake or the center stand.
What to do if choke on scooter wont start?
If the automatic choke is OK, the starter cranks the engine, there’s gas and there’s a spark then there may be an engine problem. You need to check the cylinder compression. You need a compression tester to do this. It screws in instead of the spark plug and measures cylinder pressure.
What can I use to fix my motor scooter?
USE A CARBURETOR CLEANER – these products are specially designed to remove small, performance damaging pieces of dirt trapped in these jets, spray or soak these pieces with carb cleaner for the best results. Once you have cleaned up these jets, reassemble them back to their original positions.
What causes a motor scooter to stop running?
You’d be surprised just how easily the smallest piece of dirt inside your carburetor or throttle body can cause issues for your scooter.
Why is my Kymco still running even with the ignition switch off?
Something has to be draining your battery. Try to find out what is still pulling power. What could still be running even when your ignition switch is off. Usually it’s the parking light. Depending on your make the last turn of your key after your lock, is a parking light notch.
What’s the best way to fix a Kymco?
Kymco… • Answered on Jan 02, 2021 Check the motor for a dirty commutator. This will make the motor draw too much current. Kymco… • Answered on Jan 01, 2021 Usually related to needing service or battery state. Remove the battery terminals and clean the battery posts and the connector on the wire. Fully charge the battery.
What are the problems with a Kymco bike?
1. Low coolant level. 2. Restricted radiator airflow. 3. Faulty thermostat. 4. Coolant pump or fans inoperative. 5. Vent hose crimped. 6. The air in the coolant and needs bleeding. 7. Engine idling too long or bike moving too slow. 8. Coolant too old needs to be replaced. 9. Faulty temperature sensor, wiring or connector. 10.
When to remove the code from Kymco battery?
• Answered on Jan 01, 2021 Usually related to needing service or battery state. Remove the battery terminals and clean the battery posts and the connector on the wire. Fully charge the battery. Smear both with some Vaseline and reconnect. The code should be gone.