How can I open the rear lift gate on my GMC Yukon?

How can I open the rear lift gate on my GMC Yukon?

Climb inside and an inch from bottom almost center u will see a little circle imprint in the door molding. Drill a hole their and stick a flat screwdriver in and push the catch. Door will open right up.

Why does my GM car say no start no crank?

How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.

What is a typical GM starting system wiring diagram?

Click on the image here to pull up a PDF of a typical GM starting system wiring diagram. Depending on the year, model and engine of your GM vehicle, your starting system may be less complicated or use only some of the components shown here. For example, earlier anti-theft systems didn’t communicate the same way with the PCM.

Where is the liftgate relay on a GMC Acadia?

In the dash fuse panel, locate and remove the Liftgate relay. Look at the bottom of the relay to identify terminals 30 and 87. Connect a jumper wire across the corresponding terminals in the panel and the liftgate will open. Fuse panel is located under passenger side of the dash.

Where is the fuse panel on a GMC?

Look at the bottom of the relay to identify terminals 30 and 87. Connect a jumper wire across the corresponding terminals in the panel and the liftgate will open. Fuse panel is located under passenger side of the dash. Dave Nova, GMC Technician Category: GM

How to open the hatch on a 2008 GMC Acadia?

2008 GMC: Acadia..liftgate..no other release to open the hatch (that I… We have a 2008 GMC… We have a 2008 GMC Acadia without the power liftgate. There is a touchpad on the exterior handle which releases the lock for the hatch with finger pressure and allows you to open it.

Climb inside and an inch from bottom almost center u will see a little circle imprint in the door molding. Drill a hole their and stick a flat screwdriver in and push the catch. Door will open right up.