How big is the back of a Mazda 3?
There is 351 litres of boot space in the back of the 3 – less than you’ll find in the Volkswagen Golf or Ford Focus. The space itself is well-shaped, however, with a usefully wide opening, but there’s a high lip to lift items over, with a drop on the other side to the low boot floor.
How many liters is a 2010 Mazda 3?
2.0-liter
The entry-level 2010 Mazda Mazda3 “i” is equipped with a 148-horsepower, 2.0-liter four-cylinder engine mated to either a five-speed manual or automatic transmission.
How much weight can you put in the boot of a Mazda3?
Examples: Based on a single occupant weight of 68 kg (150 lbs), and a value of 385 kg (849 lbs) for the “combination weight of occupants and cargo should never exceed”: The cargo weight limit with one occupant is 385 kg (849 lbs) – 68 kg (150 lbs) = 317 kg (699 lbs) The cargo weight limit with two occupants is 385 kg ( …
How big is the Mazda3 gas tank?
13.2 gal
13.2 gal. 343.2/462.0 mi.
When to replace brake rotors on Mazda 3?
*Replace in pairs for best performance Your ability to stop safely and dependably depends on your braking system, and the system is only as strong as each 2010 Mazda 3 brake rotor.
What causes Brake judder on a Mazda 3?
When applying the brakes, a pulsating force tries to push the brake pad back. The pulsation is transmitted to the brake pedal. 2. The following are the main possible causes of brake judder: Due to an excessive runout (side-to-side wobble) of the disc plate, the thickness of the disc plate is uneven. 1. If the runout is more than 0.05 mm {0.002 in}
What should the runout be on a Mazda 3?
1. If the runout is more than 0.05 mm {0.002 in} at the position 10 mm {0.39 in} from the disc plate edge, uneven wear occurs on the disc plate because the pad contacts the plate unevenly. 2. If the runout is less than 0.05 mm {0.002 in}
How do you do disc inspection on a Mazda 3?
1. Clean the disc plate-to-pad friction surface using a brake cleaner. 2. Measure the points indicated in the illustration using a caliper (micrometer). 3. Subtract the minimum value from the maximum, and if the result is not within the specification, machine the disc plate using a lathe. Do not exceed minimum disc plate thickness.