Does Benz use shaft?
The drive shaft or cardan shaft of your Mercedes-Benz transfers the driving power from the engine to the wheels. To ensure the drive shaft smoothly delivers the driving power to the wheels, a car has a gear box and a clutch. Over time the drive shaft gets used however.
How much is an axle for a Mercedes?
The Best in Auto Repair The average cost for a Mercedes-Benz G500 axle shaft replacement is between $2,121 and $2,321. Labor costs are estimated between $765 and $965 while parts are priced at $1,356. This range is based on the number and age of Mercedes-Benz G500’s on the road.
How much does it cost to replace a Mercedes drive shaft?
Replacing the Mercedes-Benz drive shaft at the dealer can range from $800 to $2000 depending on the Mercedes-Benz model. You can buy the part from the dealer or online and have an independent repair shop install it. The cheapest option is to buy a used propeller shaft from another vehicle and install it yourself.
What should the torque be on a Mercedes drive shaft?
Tighten the bolts on a cross pattern to the specification. The typical torque specification is 40 Nm, but you should verify this value by calling the dealer. Once you are done installing all the bolts, give them a 90-degree turn to finish the installation.
Where is the propeller shaft on a Mercedes?
In this guide, you will find instructions on how to replace the Mercedes-Benz propeller shaft, also known as the driveshaft. The propeller shaft on Mercedes cars is part of the driveline and connects the transmission output shaft to the rear differential on rear-wheel-drive vehicles.
Where are the driveshaft bolts located on a Mercedes?
Locate the driveshaft bolts at the cv joint. Note that Mercedes-Benz typically uses constant velocity (CV) joints at the driveshaft and not universal joints. Remove them one at a time. Note that you may need to turn the driveshaft to get to the top bolts.
How to change the shaft on a Mercedes driveshaft?
To get to the top bolts, you will need to lift the wheels at front or back, depending on which shaft you are changing, to turn the shaft. If you have to put the car on neutral to spin the driveshaft, do so without getting under the car. Put the car back in Park and set the Parking brakes before you get back under the vehicle.
Where is the flex disc located on a Mercedes?
The front flex disc. The one in the front connects the tranny to the driveshaft while the one in the back connects the driveshaft to the differential. The rear flex disc. The rear is easier to find, as it is conveniently located between the drive shaft and the rear differential.
In this guide, you will find instructions on how to replace the Mercedes-Benz propeller shaft, also known as the driveshaft. The propeller shaft on Mercedes cars is part of the driveline and connects the transmission output shaft to the rear differential on rear-wheel-drive vehicles.
How much does it cost to replace Mercedes flex disc?
Mercedes Flex Disc Replacement Cost. If you have an auto repair shop replace the flex disk on your Mercedes-Benz expect to pay between $300-$500 depending on your location and model of MB. If you do it yourself you can spend around $100 for the Mercedes-Benz Genuine flex disk.