Does a manual transmission have a flex plate?
Flywheels are typically found on vehicles equipped with manual transmissions, while flexplates are used in vehicles with automatic transmissions. A manual transmission has a flywheel that is attached to the crankshaft and has a clutch disk in between the pressure plate and flywheel.
Which way does a flexplate go on?
Get in, sit down, hang on If you look at the center of the flex-plate, where it bolts to the crank, you’ll notice that it is depressed as well. Install it with the depression facing the trans.
What happens when flexplate breaks?
A loose bolt on a flexplate or a crack between it’s bolt holes can result in a; knocking or rattling sound. The flexplate can become cracked over time. As a result, this can cause the it, to wobble. So, you might notice rhythmic clunking or grinding noises, while the engine is running.
Is the flexplate part of the transmission?
A flywheel is usually referenced to a car with a standard transmission,and a “flex plate” is used with automatic transmissions. The flex plate bolts to the engine crank shaft and to the torque converter of your automatic transmission.
How does a flexplate work in an automatic transmission?
Automatic transmissions eliminate the clutch and grinding. Basically automating the shifting process so the driver does not have to worry about shifting gears while driving. A flexplate is mounted to the crankshaft and connects the output from the engine to the input of a torque converter.
What kind of Flexplates did a C4 transmission use?
C4 transmissions could have used any of the three tooth count flexplates depending on the bellhousing used. In original applications, it roughly corresponded to the “size” of the vehicle the transmission came in. C6 transmissions could have used either the 157 or 164 tooth flexplates, depending on which case it had.
Where does the flexplate go in a car?
A flexplate is mounted to the crankshaft and connects the output from the engine to the input of a torque converter. Torque converters replace the clutch of a manual transmission. Allowing the load to be separated from the power source.
Where is the torque converter on a flexplate?
They are generally a type of fluid coupling that can multiply torque and is used in transferring rotating power from the prime mover (internal combustion engine or electric motor) to a rotating driven load. The torque converter is located between the flexplate and the transmission.