Does a 2002 Toyota Corolla have daytime running lights?
The DRL bulbs operate through the high beam bulbs, the DRL relay just simply runs power through a resistor first to reduce the intensity of the light beam….I have a 2002 Toyota Corolla that the daytime running …
| 23 – GROUND | : | Approx. 12 volts with the ignition SW at ON position |
|---|---|---|
| 1,12 – GROUND | : | Always continuity |
Can I disable DRL?
Please remember, daytime running lights (DRL) are a safety feature that can help make it easier for others to see the front of your vehicle during the day. If your vehicle is equipped with a “DRL OFF” setting, they can be turned off by twisting the headlight control knob to “DRL OFF.”
Why does my dash say DRL?
The DRL indicator light means that the daytime running lights are ON and operating properly. This light should turn off afterwards once the system verifies that everything is working as intended. Typically, a faulty bulb may be the culprit, but there are fuses and relays in the circuit that can cause similar issues.
What are the lights on a Toyota Corolla?
2 The side marker, parking, tail, license plate, daytime running lights and instrument panel lights turn on. 3 The headlights and all the lights listed above (except daytime running lights) turn on.
What should the battery voltage be on a Toyota Corolla?
With your Corolla turned off, you’ll connect the negative side of the meter to the negative battery post or wire. Touch the positive side of the voltmeter to the positive battery wire. With the engine off, you should get a reading somewhere between 12.0 volts and 12.6 volts.
Why does my Toyota Corolla parking light not turn off?
Parking lights will not turn off after key was removed. Tried the daylight controls, turned it completely off, lights still on. At night my headlights turn on by themselves, even though the switch is definitely off. Now, when we turn the high beam switch on after parking it, they seem to stay off.
How to inspect the wiring of a Toyota Corolla?
Wiring diagram Inspection procedure 1 Inspect radio receiver assy (ill+, ill–) Check that the voltage between terminals at each condition, as shown in the chart. Standard: Repair or replace harness or connector