Can you drill holes in PVC pipe?
The best way to make holes in PVC is by using a drill or rotary tool. PVC is soft, you can use either wood or metal bits to make holes with a drill. For making larger holes, use a hole saw with a mandrel to punch through the tube.
How do you drill large holes in plastic?
Spur-point drill bits (dowel bits) are best suited for drilling holes in plastic. The point and angle in front of these bits ensure that the stress in front is minimized and that the cut is smooth. We recommend slowing down as you are exiting to get a clean and neat hole.
What size hole do I drill for 1/2 inch PVC?
Instead of having to spend time enlarging the hole you just drilled, be sure to drill a 2-9/16″ diameter hole. This size will accommodate the PVC pipe fitting hub.
What is the best drill for PVC?
If you’re drilling PVC, it’s best to use a metal drill. This principle applies to all types of plastic. Use a standard roll-rolled or HSS ground metal drill bit. The top angle must be between 60 and 90 degrees.
How do you make the perfect hole in plastic?
Use an Electric Drill A power drill is probably one of the quickest ways to cut holes in your plastic. Drilling several small holes into the plastic can make the surface easier when you begin to cut it. It’s best to use smaller drill bits that are less than 1/8 inch in diameter.
How do you drill a PVC for a French drain?
How to Drill Holes in a Pipe for a French Drain
- Clamp the PVC pipe to a workbench or table.
- Snap chalklines the length of the pipe at 10 o’clock, 11 o’clock, 12 o’clock, 1 o’clock and 2 o’clock.
- Drill 3/8-inch holes approximately 3 inches apart down each chalk line.
How do you drill into plastic without cracking it?
You can use a hot metal rod or a drill to make a hole in plastic without cracking it. A hot rod would be better since it requires slightly less skill and it is easily available. You can repair plastic using a soldering iron, a hot rod or baking soda and superglue in case of damage.
What size hole will be drill for installing the 1 2 copper tube?
1/2″ copper is 5/8OD, you do not want the hole to fit tightly or you will get squeaking, ticking as pipe expands. As suggested 3/4″ or larger.